How do I program my Dodge Caravan?
First You need to open the driver’s door and press the lock button five times in a row on the door. Next place Your new key into the ignition and turn it one click. Next press the unlock button and panic button on the remote You are progRamming until You hear a chime.
How do you reset the computer on a Dodge Grand Caravan?
How to Reset a Dodge Grand Caravan Computer
- Pull the hood release lever under the dash to release the hood.
- Locate the hood latch under the center of the hood and push the latch to the left.
- Locate the battery on the driver’s side of the engine compartment above the front wheel.
What problems do Dodge Caravans have?
Dodge Grand Caravan Common Problems The current Dodge Grand Caravan generation debuted for 2008. Since then, drivers have complained about a number of frequent issues, including premature brake wear, engine stalling, hard gear changes, transmission failure, and faulty air conditioning.
Why does my Dodge Caravan not start?
The most common causes that hinders normal starting operation of your Dodge Grand Caravan are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.
How do you reprogram a Dodge Caravan key fob?
Press and hold the Unlock button on the auto ignition key and press the Panic button on your remote. Release both at the same time after holding for five seconds. Wait for a chime to indicate the programming sequence has begun.
How much does it cost to reprogram an ECM?
If the engine control module just needs to be tested, analyzed, and reprogrammed, it should cost you between $150 and $300. As with buying new, if you have someone else install your replacement remanufactured ECM, you could be looking at additional hundreds of dollars of labor costs.
How do you reset the computer on a 2001 Dodge Caravan?
Disconnect the battery for 1 minute and re-connect. start the vehicle and hold the revs at 1800-2000rpm for 10 seconds let the revs lower on their own then turn the a/c on and repeat. this will reset the base idle of the engine.