How do I manually override my thermostat?
Keep the display button depressed and let go of the off button. While still holding the display button, quickly press the up arrow button. Release all depressed buttons at the same time. This should put the thermostat in a manual mode.
How do I lock my Aube thermostat?
LOCKED IN AUTO MODE
- Press the MODE button to place the thermostat in AUTO. mode.
- Press on the PGM button and enter the desired. programming (see the Suggested Typical Programming. section in the instruction sheets).
- Press on the RET button to end the programming. Wait a.
What are the functions of the Aube Th232 thermostat?
The Aube TH232 thermostat gives you 3 functions in 1, allowing you to control your heating system by measuring: A combination of air & floor temperature. Please note that when a contactor is used you will need to fit a snubber (surge protector) on the switch terminals (A1 & A2).
How many amps can an Aube thermostat switch?
The Aube range is capable of switching a maximum of 15 amps, giving you the ability to switch multiple mats whilst using one thermostat control. For an area that requires a single thermostat to control a load greater the 15 amps, a suitably sized contactor should be installed, which can then be controlled by the thermostat.
Why do I need an Aube thermostat for my bathroom?
The Aube thermostat was purchased as it has an ‘Ambient’ mode which demands heat with regards to the air temperature of the room to be heated. I was thus able to restore heating to the bathroom without having to rip up tiles and replace the sensor cable.
What do you need to know about the Aube range?
The Aube range has been designed to provide total control and flexibility when using your underfloor heating system. An option of both manual and fully programmable controls are available, allowing you flexibility of the product.