How do I change the battery in my Bose Soundlink 2?

How do I change the battery in my Bose Soundlink 2?

1. Step 1 Battery. Flip the speaker over onto its back.
2. Gently remove the rubber base from speaker by pulling around the edges.
3. Remove the four 6mm T9 Torx bit screws from the corners of the battery.
4. Carefully lift the battery from the side nearest the four gold contact pins, but don’t try to fully remove it yet.

Can a Bose Soundlink battery be replaced?

The battery in your product can be removed so you can insert a new battery if your battery weakens or dies.

How do I check the battery on my Bose SoundLink 2?

To check the charge level, press and hold the Power button and observe the battery indicator. The battery status LED will always be a half full battery symbol.

Why is my Bose speaker not holding a charge?

If your Bose speaker isn’t charging, it could be down to the battery, charging circuit, or charging port. If your speaker isn’t holding a charge, it may need to be reset. If this fails to work, then the battery may need to be replaced.

What is the battery life of Bose SoundLink?

about 6 hours
When fully charged, the battery typically provides about 6 hours of playing time at a moderate volume levels. Battery power is consumed faster at higher volume levels. The typical life span of the battery is about 300 charge cycles.

How do you fix a Bose speaker that is not charging?

Battery will not charge

1. Disconnect and reconnect the charging cable at both ends.
2. Reset your product.
3. Check if the connected power outlet is working.
4. Try a different charger.
5. Check that the USB charger meets the power requirement of your product.
6. Your product may need service.

Why is my Bose speaker flashing yellow?

If your Bose Bluetooth speaker is flashing or blinking amber there’s no need to worry. When plugged in, a flashing amber light means that the battery is charging.

What is the battery life of Bose Soundlink?

How do I reset my Bose Soundlink?

To reset your product: On the top of the speaker, press and hold the Mute button for 10 seconds. The product lights flash, then turn off once reset.