How can I tell if my Harley Davidson has no spark?
A lot of folks have good service with the PC but others have had problems with them failing or blowing an internal fuse in the PC. A crude first step coil test is to read the ohms across the primary and then across the secondary terminals. The primary side shouldn’t read much ohms (around 3 or so).
Why is there no spark to my spark plugs?
There was no spark to the plugs. Was turning over real good. No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started. Then a couple of days later it did the same thing, so spark.
Why does my 8N tractor have no spark?
1) It’s has gas, and the engine is getting gas. 2) There is no spark at the plugs. (tested by pulling plug wire and inserting screw driver into plug wire and trying to jump a spark to ground. 3) It has voltage to the input side of the coil. I replaced the coil – no change in symptom.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
Why does my 2006 heritage have no spark?
I have a 2006 Heritage. There was no spark to the plugs. Was turning over real good. No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started.
A lot of folks have good service with the PC but others have had problems with them failing or blowing an internal fuse in the PC. A crude first step coil test is to read the ohms across the primary and then across the secondary terminals. The primary side shouldn’t read much ohms (around 3 or so).
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
What should the spark plug be on a Dyna?
Just disconnect it from the regulator and test the CPK side of the connector. I checked for a Dyna the primary coil side should only be between 0.3 and 0.5 ohms. I remembered 3 ohms from somewhere, maybe it was my truck. Anyhow if your coil is a sealed unit you will have to test the plug going in it.
I have a 2006 Heritage. There was no spark to the plugs. Was turning over real good. No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started.