Does new conductor plate need to be programmed?
The new conductor plate comes pre-programmed and ready for fitment. 722.6 does not need coding in most cases. However, you still need to clear the codes and run a calibration procedure to ensure the best results.
How much does it cost to replace a transmission conductor plate?
The price of a replacement automatic transmission conductor plate is usually around $100 up to $250. Of course, the price may vary depending on your car’s year, make, and model. An aftermarket automatic transmission conductor plate can be purchased per unit or as part of a kit.
What does the conductor plate do?
The Transmission Conductor Plate is a part of the transmission system. The plate is mounted on the valve body of your automatic transmission. The pressure relief valves, shift control valves and speed sensors are mounted on the plate. The conductor plate transmits the signals to the valves from the control module.
How do I reset my w202 gearbox?
Depress accelerator pedal fully to kickdown and hold it for fifteen seconds. release the pedal and switch off. Wait for three minutes without operating anything. Don’t open the doors or operate the interior lights, radio or anything else.
What is a valve body?
The valve body is the control center of the automatic transmission. It contains a maze of channels and passages that direct hydraulic fluid to the numerous valves which then activate the appropriate clutch pack or band servo to smoothly shift to the appropriate gear for each driving situation.
Where is the Transmission Control Module?
The transmission control module can often be found below the cover at the back of the transmission case. It should be just below the engine control module’s position. Sometimes it’s found under the center console in the interior or even under the hood near the battery or inner fender panel.
How to remove transmission valve body conductor plate?
Locate and remove the T30 Torx bolts that hold the valve body and conductor plate assembly in place. Do this in a zig-zag pattern. Lower the valve body assembly from the car. Working on a clean table or workbench, remove the yellow plastic covers at the top side of the conductor plate.
How to change conductor plate on Mercedes 722.6 5G transmission?
Instructions on how to change the conductor plate and valve body on Mercedes-Benz 722.6 5G transmission. Allow the car to cool down. Raise your car using a car lift, ramps, or jack stands. Secure the vehicle with jack stands. Set parking brakes.
When to replace the Transmission Control Module ( TCM )?
When only one or two gears of a vehicle are working, it is said to be in “limp mode”. Limp mode is the vehicle’s safety default mode, and the automobile needs to have the TCM replaced for it to be driven again safely.
How to reset transmission adaptive shifting in Mercedes Benz?
If you race your Mercedes-Benz, it will remember that and keep the gearbox in gear longer. If you drive it gently, it will adapt to that as well and change gears earlier. Turn the key to position 2. You should see all the dash lights come on. Do NOT start the car.