Does a 2005 Honda Civic DX have VTEC?
Engine: The Civic DX and LX come with a 115-hp 1.7-liter 16-Valve SOHC engine. Honda Civic 1.7-liter VTEC engine. The EX is equipped with the 127-hp 1.7-liter SOHC VTEC (Variable Valve Timing and Lift Electronic Control). 2005 Honda Civic.
How much HP can a 2005 Honda Civic DX make?
2005 Honda Civic Sedan Specifications
| 2005 CIVIC SEDAN | DX | EX |
|---|---|---|
| Type: Aluminum-Alloy In-Line 4 | x | x |
| Displacement (cc) | 1668 | 1668 |
| Horsepower @ rpm (SAE net) | 115 @ 6100 | 127 @ 6300 |
| Torque (lb.-ft. @ rpm) | 110 @ 4500 | 114 @ 4800 |
How much HP can you put in a Civic?
A manual-transmission 1.5-liter Civic can put out about 225 horsepower and 254 pound-feet of torque, a far cry from the 174 horsepower and 167 pound-feet of a base Civic. CVT models will see a lower output, but it’s still pretty impressive at roughly 214 horsepower and 220 pound-feet of torque.
What kind of clutch does a Honda Civic have?
This article breaks down a complicated process and takes you step-by-step in how to correctly replace the flywheel and clutch on your Honda Civic. This article applies to the Honda Civic (1992-2000). Your Honda Civic uses a hydraulic clutch system to engage the transmission into the gears.
How do you replace the flywheel on a Honda Civic?
Use the following steps to replace the flywheel and clutch on your Honda Civic. The quickest way to reach the clutch is from underneath the chassis. In order to do this, use a jack to raise the vehicle and a pair of jack stands to support the chassis in the air. Also use this as an opportunity to drain the transmission fluid. Figure 1.
Where are the transmission bolts on a Honda Civic?
Remove the transmission top mount’s 17mm bolts. Proceed to remove the front transmission mount (three 17mm bolts and two 14mm bolts). Remove the final 19mm mount bolt located behind the transmission. Once done, loosen all four bolts that connect the transmission housing to the engine.
Where is the pressure plate on a Honda Civic?
Take the pressure plate and mount it on top of the clutch plate. Position the pressure plate so the three studs on the flywheel are visible. Once fitted, tighten the pressure plate bolts to 19 ft/lbs using a criss-cross pattern.