Do you need torque specs for a C15 Acert?
Looking for torque specs for a C15, doing a Platinum overhaul and need specs for most bolts. Rods, mains, head bolts, rocker shafts, injectors, cam … read more
What should the Jake be on a C-15 ACERT?
The jakes are tricky, too. It helps to flash those engines to 550 HP/1850 torque when you run the overhead, if it hasn’t already been uprated. The stock factory injectors will handle this file
How to adjust the ACERT valve on a C-15 ACERT?
If both rockers on #1 are loose, then you have the engine pinned at #1 Top Dead Center. If they are tight, and both rocker arms on #6 are loose, then you are #6 TDC. Then adjust the Jakes over 1, 3 & 5. Rotate the engine one full turn & pin the flywheel again.
How much torque does a Caterpillar C15 engine have?
CATERPILLAR C15 Essential Diesel Engine Bolt Tightening Torques CAT C15 Main Bearing capscrews step 1 = 95 Nm, 70 lb.ft step 2 = 260 Nm, 190 lb.ft
What are the dimensions of a cat C15?
CAT C15 Dimensions approx: length 1381 mm, 54.37 in width 926 mm, 36.47 in height 1248 mm, 49.15 Click for CAT C15 engine manuals and specs. CAT C15 Weight approx: 1469 kg 3239 lb Click for CAT C15 engine manuals and specs. CAT C15 Compression ratio 18.0:1 Click for CAT C15 engine manuals and specs.
How are the rods oriented on a crank?
If the rods are designed for use on a crank that does not feature a radiused fillet, the rods may not feature a large chamfer on one side. Rod orientation can then be obtained by orienting rod with its bearing tang grooves biased toward the pan rail (outside) or cam side (inside).
What are the torque specifications for a car?
The specified amount will normally be in 30° increments. Turns of 120° or 180° are preferred. Turns of 120° or 180° are easily measured by the points of the hex head of the fastener. Lubrication may be specified in order to reduce the effort that is required for the final turn.
What are the torque specs on a CAT C-15?
Head bolts 200/330/330.main caps 180-200 then 115-125 degrees.rods 59-71 then 85-95 degrees. Thats what my motors manual says . Hope this helps This does refer to the C15 Acert right?
What happens when the torque is too much?
Too much tension on the bolt will cause the bolt to be stretched beyond the point of yield. The bolt will be permanently stretched. The bolt will loosen the grip on the parts that are being fastened. If the bolt is tightened again, the bolt will break. Do not reuse bolts that have been permanently stretched.