Do you need to add Slack to clutch cable?
With the clutch cable cover out of the way, you will need to add slack into the cable. Doing this is essential to ensuring that the cable has no affect on the clutch as it is being adjusted later on. By adding slack into the clutch cable, what you are actually doing is collapsing the cable housing that the cable pushes against.
Can a jiffy stand cause a motorcycle clutch to leak?
Protip 1: If your bike is sitting on a jiffy stand, it is possible (though not probable) that, due to the angle, some of the primary fluid could leak out if it is overfilled. It is always a good idea to place a rag underneath your motorcycle to guard against gunking up any surfaces that you don’t want to gunk up.
How to adjust a motorcycle clutch on a Harley Big Twin?
With the clutch adjusted, snug down the jam nut with your screwdriver. RevZilla photo. With the fight against clutch malfeasance won, it’s time to shield back up and reattach the clutch cover. When doing this on your Harley Big Twin, it is a pretty simple process. Always start this process with your fingers to get the bolts going.
Where is the clutch cable cover on a Honda Accord?
Designed to protect the clutch adjuster mechanism from dirt, water, and particularly juicy airborne arthropods, the clutch cable cover (or “boot”) is the accordion-looking piece of rubber that resides about half way between your handlebars and the bottom of your Big Twin frame.
With the clutch cable cover out of the way, you will need to add slack into the cable. Doing this is essential to ensuring that the cable has no affect on the clutch as it is being adjusted later on. By adding slack into the clutch cable, what you are actually doing is collapsing the cable housing that the cable pushes against.
Designed to protect the clutch adjuster mechanism from dirt, water, and particularly juicy airborne arthropods, the clutch cable cover (or “boot”) is the accordion-looking piece of rubber that resides about half way between your handlebars and the bottom of your Big Twin frame.
With the clutch adjusted, snug down the jam nut with your screwdriver. RevZilla photo. With the fight against clutch malfeasance won, it’s time to shield back up and reattach the clutch cover. When doing this on your Harley Big Twin, it is a pretty simple process. Always start this process with your fingers to get the bolts going.
What’s the proper way to tighten clutch on a motorcycle?
Much the same as tightening the lug nuts on your car tires, working in this pattern helps to ensure that the cover evenly draws down against the seal. When reattaching the clutch cover, it is important to tighten the screws in a star pattern (like you would with lug nuts).