Do td5 injectors need coding?
They need to be coded in when they are replaced, using the number. Jonv8 will tell you properly, he’ll have done it.
Where is the ECU on a Discovery td5?
Your ECU is next to the battery. Remove the black cover & you will see a silver box. Thats it.
How do I remap my Td5 with Nanocom?
Using the USBBDM as a remap interface
- Copy tune to SDCard.
- Place SDCard in Nanocom.
- Connect Nanocom to OBD port.
- Wait for Nanocom to boot.
- Navigate to Td5 Map module.
- Select .map.
- Wait for Nanocom to verify checksum and “protection”
- Turn on ignition, then push button on Nanocom.
How do I exit Nanocom?
-c, –exit-char The exit character where the Ctrl key and this character are used to exit the client.
What is HDC fault?
HDC is sensitive to differences in voltage across the vehicle’s electrical systems. If you see the “HDC Fault System Not Available” message while the brake warning light or ABS warning light are illuminated, this can indicate a failure in any or all of these systems.
Why is my Land Rover screen not working?
The Land Rover Discovery 4 touch screen not working can be caused for a variety of reasons such as a software issue, faulty wiring, or a blown fuse.
What does gearbox fault mean on a Range Rover?
The gearbox fault message is often triggered by insufficient battery voltage. It’s a strange sort of Land Rover code – you know, gearbox fault REALLY means battery bad.
What should I do about my Land Rover Td5?
There are plenty of good ones out there. TD5s are sensitive to overheating so make sure the cooling system is tip top. Regular oil changes every 5k miles will keep the TD5 engine running like a sewing machine. Other than that they are a good strong engine with oodles of potential in terms of tuning.
What are the firing order of the injectors on a Land Rover?
The numbers on cam are the firing order. Firing order is 1,2,4,5,3. Remember that with every injector you set you need to ensure the rocker is at top dead centre on the cam. At this point double check the rocker and injector bolts torque.
Why is the peak charge off on my Td5?
The ECU is constantly listening, through the CKP sensor, to the result each injection and stroke cycle produces on the flywheel. If injector signal delivery or fuel availability are compromised then a ‘mismatch’ occurs between what the ECU wants (commands) and gets. And it blames it on the injectors by saying the peak charge was off.
How often should I Check my injector seals?
Check it every couple of weeks. If it’s going UP, you have a problem, and injector seal failure is one of the possible causes. The most siginficant thing to watch out for and easy to monitor is your sump oil level. Check it every couple of weeks.