Can you use old races with new bearings?
You can check the condition of your hub’s races by carefully removing all bearing grease with a rag to expose the actual surface of the races. If you are doing this bearing replacement before any excessive wear or damage has occurred then you may be fine leaving the original races in the hubs.
When to replace wheel hub bearings on an ATV?
If it’s been a while since you’ve last replaced them, or you have an older machine, it’s a good idea to do the replacement if your sure the problem isn’t your brakes or tires. To do a manual check, jack up the wheel in question and try to move it back and forth.
How can you tell if wheel hub bearings are bad?
You’ll be able to tell if your wheel hub bearings are bad by the way your ATV or UTV is handling. One of the most common symptoms is a grinding sound and feeling when riding. You may also hear some clanking or banging type sounds coming from the wheel hub.
How to install a new strut on a Honda Odyssey?
Installing the New Strut Bearing and Strut Mount 1. Clean the contact surface where the new bearing is to be mounted. 2. Position the strut assembly upright and install the new bearing and strut mount. 3. Torque on the strut stem nut using the same tools during removal. 4.
Can you replace the stabilizer link on a Honda Odyssey?
Hardlymoving writes about do-it-yourself automobile maintenance on various makes and models. This article provides you step-by-step instructions for replacing the upper strut mount and the stabilizer link for a Honda Odyssey. The repair was performed on a 2002 Odyssey.
When to replace the hub assembly and wheel bearings?
You should replace your hub assembly and wheel bearings. Here’s how to replace wheel bearings. Even if only one side is bad, it makes sense to replace them in pairs. The “good” side is likely to cause problems in a relatively short time. Also, after driving the car, you can check the temperature of the hub assembly.
Where can I get a new wheel bearing?
If your bearing is pressed into the spindle, it is recommended that you remove the spindle from the vehicle and take both the spindle and the new wheel bearing to your local repair shop. They will have the specialty tools to press out the old bearing and press in the new one. In most cases this service can be done inexpensively.
Why are my wheel bearings making strange noises?
Having said that, although noises from bad hub assemblies and/or wheel bearings come from the area of your wheels, not all strange sounds from the area of your wheels is assembly- or bearing-related. They could indicate a problem with your brakes or CV joints.
How do you remove a wheel hub assembly?
Then start disassembling the brakes by removing the caliper bolts and the bracket bolts. Next, remove the rotor. If the vehicle has anti-lock brakes, disconnect any wiring harness plugs. Loosen all the bolts that hold the wheel hub assembly onto the knuckle. Once that is done, you should be able to remove the wheel hub assembly as a unit.