Can you smash up a cast iron bath?

Can you smash up a cast iron bath?

A sturdy lump hammer rather than a sledge hammer. A old dust sheet or bit of carpet will help stop the enamel flying about too much when you hit it. Start by smacking out waste work you way up to the overflow. Move to other end, bottom of the slope and work you way up.

How long does a cast iron bathtub last?

Miracle Method, like many refinishing companies, offers a five-year warranty. But says Diane Robbins, co-owner of the franchise that resurfaced Jackie’s tub, with proper care and maintenance (nonabrasive and bleach-free cleaners only), a refinished cast-iron tub surface should last 15 to 20 years.

Can you break a cast iron bathtub with a sledgehammer?

Break the tub apart with a sledgehammer if you don’t want to keep or sell it. Start by covering the cast iron with a heavy blanket or towel. Put on some goggles and a long-sleeve shirt and use a 16 lb (7.3 kg) sledgehammer to break the tub apart until it’s in smaller pieces.

How much does it cost to remove a cast iron tub?

Cast Iron Tub Removal Cost. To remove a standard cast iron tub, you can expect to pay anywhere from $255-$395. Based on where the tub is location in the home or on the property, your cost could be more.

Can you break cast iron with a hammer?

Hit the back of the chisel with a hammer. Move the chisel along the cast iron pieces while striking it with the hammer until the larger pieces break. Continue with the chisel and hammer until the cast iron breaks into manageable pieces.

How do you remove bathtub sunken?

How to Replace a Sunken Tub

1. Step 1: Shut Off the Water Supply.
2. Step 2: Locate the Plumbing Access Panel.
3. Step 3: Remove the Faucet and Spout.
4. Step 1: Disconnect Supply and Drain Pipes.
5. Step 2: Remove Floor Covering Around Tub.
6. Step 3: Break the Rim Free.
7. Step 1: Lift Old Tub Out.
8. Step 2: Remove Old Mortar.

Can you fix a cast iron tub?

Here are a few products you can use to repair your cast-iron tub. If you go the route of the clear epoxy and paint, you’ll need high-gloss paint mixed to match the color of your cast-iron tub. The epoxy does NOT shrink as it dries. Work with great light and don’t overfill the chip.