Can you remove the rear timing cover on a VQ35DE?
The problem with the service manual is that it specifies removing everything, including the rear timing cover, so it has you remove a lot of things that are unnecessary, like the valve covers and variable valve timing solenoids. I didn’t remove them to do mine, but you can if you’d like. Just need to get more gaskets and o-rings.
How do you set ignition timing with no timing marks?
Rotate the engine very slowly back and forth until the screwdriver is at the maximum height. This indicates the number one cylinder is at Top Dead Center or “TDC” on the compression stroke. Locate the number one spark plug wire on distributor cap and make a tic-mark of this position with a marker pen on the distributor housing.
How do you change the timing on a spark plug?
Loosen the distributor hold down bolt and turn distributor until the rotor is lined up with the mark you made in Step 3. Your timing is now set to zero degrees of mechanical timing. Replace the valve cover using a new gasket. Replace the spark plugs and spark plug wires using the marks from Step 1.
How do you change the ignition timing on a V-block?
Remove all the spark plugs using the spark plug wrench. The engine will be easier to turn by hand with the spark plugs removed and it’s a good time to replace them if required. Remove the valve cover from over the number one cylinder. On a V-block engine this is normally the valve cover on the driver’s side.
What do I need to replace timing chain on VQ35DE engine?
I’m doing it with the engine out of the engine as I’m swapping it into a 5.5 Gen, so the upper oil pan is already removed and I’ll be going from there. Most stuff I’ve seen in my travels says to replace all three chains, the main tensioner, the top guide, the slack guide, and the two small guides in the camshaft chains.
Rotate the engine very slowly back and forth until the screwdriver is at the maximum height. This indicates the number one cylinder is at Top Dead Center or “TDC” on the compression stroke. Locate the number one spark plug wire on distributor cap and make a tic-mark of this position with a marker pen on the distributor housing.
Loosen the distributor hold down bolt and turn distributor until the rotor is lined up with the mark you made in Step 3. Your timing is now set to zero degrees of mechanical timing. Replace the valve cover using a new gasket. Replace the spark plugs and spark plug wires using the marks from Step 1.
Remove all the spark plugs using the spark plug wrench. The engine will be easier to turn by hand with the spark plugs removed and it’s a good time to replace them if required. Remove the valve cover from over the number one cylinder. On a V-block engine this is normally the valve cover on the driver’s side.