Can you pass inspection with P0128 code?
yes,any code will. if the check engine light is on,which it is,it won’t pass. copy and paste the link below.
What does P0420 mean on a check engine light?
During normal operation, if those two O2 sensors indicate the same readings, the catalytic converter will not be operating within specifications. This will result in higher than normal oxygen levels. Thus, it will also signal the ECU to store the P0420 code and turn on the check engine light.
Why is my Check Engine light illuminated due to p0128?
When your check engine light is illuminated due to trouble code P0128, you may have an issue with your engine thermostat. Here are some helpful steps to take to find out how do I fix trouble code P0128? Learn how to solve this trouble code and repair your thermostat.
What should I do if I have a p0128 trouble code?
Your intake air temperature sensor, coolant temperature sensor and coolant fan could also signal this trouble code, so these should be inspected after you look over your thermostat and coolant level. Start with the easiest repair solution, which is low coolant levels.
What causes a catalyst monitor to set code P0420?
A typical catalyst monitor uses the signal from the downstream oxygen sensor to determine catalyst efficiency, and the signal from the upstream sensor is a reference point. As such, failure of either the upstream or downstream oxygen sensor can cause code P0420 to set. The most common cause of the code]
What does the OBD-II P0420 error code mean?
The definition of the OBD-II P0420 code is “Catalyst System Efficiency Below Threshold (Bank 1)”. When the ECU stores this code, it means that the catalytic converter is not operating at maximum efficiency and may need replacement.
What does it mean when your catalytic converter says P0420?
It is important to note that the ignition, fuel and air intake systems can contribute to damaging the catalytic converter. As a matter of fact, these systems are the most frequent causes of the P0420 error code. For this reason, we recommend that these systems are thoroughly checked out before replacing the catalytic converter.
Why does my Toyota Corolla have a P0420 trouble code?
The most common cause when you find the P0420 on the Toyota Corolla is a bad catalytic converter. But, this can often be caused by oil going through the piston rings to get stuck on the catalytic converter if you have a Toyota Corolla that is struggling with the trouble code.
What causes the O2 sensor to show the code po420?
Rich or lean mixtures can damage the catalytic converter, and when the catalytic converter is damaged/filled with fuel, the efficiency will be low, and the rear O2 sensor will see that and show the trigger the code Po420.