Can we stack 3750G and 3750X?
You cannot run two different IOS versions between them, they have to be the same version number. The 3750G’s latest IOS is 150-2. SE10a, so you will also need this same version for your 3750X. Once the IOS version is exactly the same on both you can stack them.
Can you stack 2960s and 2960X?
The 2960X allows stacking of up to eight switches and can provide up to 80 Gbps bandwidth with FlexStack+. All switches in the stack must be running the LAN Base image. In a mixed stack of Catalyst 2960-X and Catalyst 2960-S switches, the number of supported stack members is reduced from eight to four.
How do I remove a provisioned switch from stack 3750?
Complete these steps in order to remove a switch: Power off the new stack member to be removed….Resolution
- Issue the switch stack-member-number provision type command.
- Power off the new stack member.
- Reconnect to the existing switch stack through the StackWise ports.
- Power on the new stack member.
What is stack priority?
Priority value in the switch stack determines which switch will become the master. A higher priority value for a stack member increases the probability of it being elected active switch and retaining its stack member number. The priority value can be 1 to 15.
What are the benefits of switch stacking?
Benefits of the Switch Stacking
- It reduces the management overhead.
- By reducing the required number of switches, it also reduces the cost of the network.
- It allows us to add or remove switches at any time without disrupting the running network or affecting its performance.
What is provisioned switch in stack?
If a switch that previously joined a stack is removed, the port numbers remain in the running-configuration, and the missing switch is shown as Provisioned. The Provisioned state might be caused by a switch that is no longer connected to the stack or be the result of manually pre-provisioning the related ports.
How do I remove a provisioned switch from stack?
If you remove a provisioned switch from the switch stack, the configuration associated with the removed stack member remains in the running configuration as provisioned information. To completely remove the configuration, use the no switch stack-member-number provision global configuration command.
Who is the stack master for Cisco 3750 switch?
All stack members are eligible stack masters. If the stack master becomes unavailable, the stack members that remain participate in the election of a new stack master from among themselves. A set of factors determines which Cisco EtherSwitch service module or Catalyst 3750 switch is elected as the stack master.
What is the SDM template for Cisco Catalyst 3750?
The Cisco Catalyst 3750 series switches use Switch Database Management (SDM) templates to optimize the system resources for specific features dependent on how the switch is used in the network. There are two versions of the SDM templates: Desktop and Aggregator.
Is the Catalyst 3750 compatible with Cisco IOS 12.2?
Catalyst 3750 switches that run Cisco IOS ® Release 12.2 (25)SEB are compatible with Cisco EtherSwitch service modules that run Cisco IOS Release 12.2 (25)EZ. Catalyst 3750 switches and Cisco EtherSwitch service modules can be in the same switch stack.
What is the default member number of a 3750 switch?
The default stack member number of a 3750 switch is 1. When it joins a switch stack, its default stack member number changes to the lowest available member number in the stack. Stack members in the same switch stack cannot have the same stack member number.