Can t get key out of ignition saturn?
Wiggle the Steering Wheel Give the wheel a wiggle while lightly trying to turn the key out of the ignition. If the steering lock is causing a bind, this will relieve the pressure and get the key out.
How to troubleshoot the ignition system in a Saturn Ion?
It primarily involves checking for sparks on the spark plugs and ignition coils. Remove a park plug wire from the plug and connect it to a spark tester. Ground the tester to the engine, crank the engine and look for a strong spark. Repeat for all the Ion’s wires.
What to do if your ignition system is not working?
Most causes of ignition system problems can’t be corrected by a non-expert, but there are a few things you can do to discover a problem’s location. It primarily involves checking for sparks on the spark plugs and ignition coils. Remove a park plug wire from the plug and connect it to a spark tester.
What should crankshaft resistance be on Saturn Ion?
Measure the resistance between the crankshaft position sensor’s terminals A and B. (Disengage the DIS module’s five-pin connector first). The resistance should be 700 to 900 ohms. Remove the crankshaft sensor from the engine if the resistance was off.
What should I do if my Saturn ignition is not working?
Turn the ignition key and try to start the engine. If the battery is known to be fully charged, the Saturn should start. If there is an error in the ignition switch, you will not hear the typical faint “click” when you initially turn the ignition key to the “III” position to crank the engine.
How does the ignition switch work on a Saturn?
Saturn vehicles use a transponder inside the ignition key to prevent unauthorized engine starting. There is a component inside the dash and linked to the ignition switch that sends a signal to the starter motor allowing the vehicle to start.
Where is the starter fuse on a Saturn?
Open the fuse panel under the steering column by turning the knob on the fuse panel counterclockwise and pulling down on the cover. Locate the fuse for the starter in the fuse panel using the fuse diagram on the underside of the fuse panel cover.
What to do if you have ignition switch problem?
If you are experiencing problems with your ignition key or switch, you may need a simple key reset or you could have a faulty ignition switch that needs to be replaced. Open the fuse panel under the steering column by turning the knob on the fuse panel counterclockwise and pulling down on the cover.