Can cables touch radiator?
Yes, radiators don’t get hot enough to cause any problem. i would imagine that a radiator getting hot enough to melt the cable would cause you rather more serious problems than stopping you getting your fix of Eastenders or Corrie!
Can I run an extension cord under a radiator?
Don’t run extension cords under rugs, under furniture, or behind radiators or heaters. As electricity passes through the extension cord, it generates heat which needs to vent to prevent the cord from overheating. Covering a cord can create a fire hazard. An extension cord is meant to be a temporary power source.
What causes a wiring harness to stop working?
If there isn’t any electricity flowing to the accessory, the problem may caused by a faulty wiring harness or a bad switch. To test the wiring harness, first remove the wires connected to the accessory. Carefully trace the wires back to the first connection point you encounter.
What kind of wiring does a Hyundai radiator use?
This is a typical Hyundai wiring diagram for the radiator fan and AC condenser fan. The system uses a radiator fan relay and a condenser fan relay. Both receive power from fusible links, not ordinary fuses.
How can I tell if my car wiring harness is broken?
If the wires are enclosed in a flexible plastic tube, carefully remove the tube so you can see and feel the wires. Visually inspect each wire, looking for any spots where the plastic covering has worn away, exposing bare copper wire. These are problem areas and need to be repaired.
What should the resistance of a wiring harness be?
In good circuits, where the wire is functioning properly, resistance should be .3 ohms or less, or .5 at the most. Repeat this procedure for the other wires in the wiring harness until the bad section is identified.
If there isn’t any electricity flowing to the accessory, the problem may caused by a faulty wiring harness or a bad switch. To test the wiring harness, first remove the wires connected to the accessory. Carefully trace the wires back to the first connection point you encounter.
If the wires are enclosed in a flexible plastic tube, carefully remove the tube so you can see and feel the wires. Visually inspect each wire, looking for any spots where the plastic covering has worn away, exposing bare copper wire. These are problem areas and need to be repaired.
In good circuits, where the wire is functioning properly, resistance should be .3 ohms or less, or .5 at the most. Repeat this procedure for the other wires in the wiring harness until the bad section is identified.
Where does the engine harness go on a corvette?
The Engine Harness runs along the upper part of the firewall (below the windshield). The Forward Lamp Harness runs along the driver’s side fender. The 53-57 Corvette Charging System wiring was incorporated into the Dash Harness.