Can bad motor mounts damage CV axles?
at worst case, it will cause misalignment on the CV joints and cause the joints to wear out. every time you hit a bump or turn the car, the CV joints move at 10x greater angles than would be caused by bad engine/tranny mounts.
Do you need an alignment after replacing CV joints?
Yes. Anytime you disassemble and reassemble any parts of the suspension or connected components, you will need an alignment afterwards.
How much would it cost to change CV joints and tie rods?
Costs can range from $149 to $399 for parts, while parts and labor will range from $235 to $1178 depending on the amount of work involved.
How long can you drive on a damaged CV joint?
These cannot be repaired – only replaced. You can drive on a damaged CV joint for a little while at least, but there’s no telling how long it will last. There are many factors, such as where you drive, the amount of dirt/dust/debris in the areas you drive, how much water gets into the joint, and more.
How do you replace a CV joint on a Toyota?
This is why a lot of people choose to replace it themselves, and it’s really not very difficult. To fix it yourself, you’ll need a torque wrench and sockets to break the main CV joint lock-nut loose, and be prepared to have to take out the lower ball joint as well.
Where does the strut mount go on a Toyota?
The MacPherson strut front suspension consists of a coil-over strut type support that bolts directly to the steering knuckle. It turns as an assembly when the front wheels turn, pivoting on the lower ball joint at the bottom, and the upper strut mount at the top.
Can you replace the strut on a Toyota Camry?
The 19mm nut is removed from the top of the damper, and the strut can be disassembled. If the bellows and spring seats are worn, it is recommended to replace them while the strut is taken apart. The strut mount used in this video was from Mevotech, part number MP904989. The vehicle demonstrated here is a 2004 Toyota Camry V6.
Why do rear wheel drive vehicles have CV joints?
Rear wheel vehicles and 4WD vehicles also have CV joints. They serve the purpose of transferring torque from the transmission to the wheels on your Toyota at a constant speed. They also handle the up and down motions of travel through the suspension.