Can a Honda Accord piston ring be replaced?
Corrective action: Honda dealers will replace piston rings as necessary, update the powertrain control module software and replace oil-fouled spark plugs. Warranty info: This replacement service is being performed free of charge under a special warranty extension good for eight years and unlimited mileage from the original vehicle-in-service date.
How do you replace internal seal on Honda Accord?
Simple remove it, rotate it 180 degrees, and re-install it. This is an optional step, but if you have the dizzy out and are going to replace the inner seal, you might as well replace the outer O-ring also.
Can you change the distributor on a Honda Accord?
Changing the seals inside the distributor is easy enough to do that you shouldn’t have to buy a whole new distributor. Learn more about this DIY job here. This article applies to the Honda Accord (1990-2002). The distributor on your Accord, like any other car, makes sure that the spark plugs fire in the correct order.
What to do if your Honda distributor comes off?
The distributor will come off now if you wiggle the unit with both hands. If it feels like the distributor is stuck on, you may use a flathead screwdriver to pry it loose (photo 4) but do not use excessive force. Step 4: Replace Distributor Outer O Ring.
How to replace internal seal of distributor in Honda Accord?
Simple remove it, rotate it 180 degrees, and re-install it. This is an optional step, but if you have the dizzy out and are going to replace the inner seal, you might as well replace the outer O-ring also. This is just pennies in cost for the peace of mind and preventing having to do this again soon.
How to replace black cap seal on Honda Accord?
Figure 5. An optional replacement step is for this black cap seal. Flip the dizzy over and use a small pen knife or flat head screwdriver to carefully remove the retaining ring, pin (should just fall out), and rotor. Make sure that you note the correct position of the rotor and replace it in the same way.
Why is the distributor on my Honda Accord going bad?
The distributor on your Accord, like any other car, makes sure that the spark plugs fire in the correct order. The dizzy, as it is commonly called, has a couple of seals and O-rings inside that will go bad over time. This can cause a small oil leak and will eventually start creating worse problems if you don’t fix it straight away.
Do you have to put Dizzy back on Honda Accord?
The dizzy must be put back on in the same position as it was removed. After you’re done with this job, if your car doesn’t start or is misfiring badly, you probably put the dizzy back on 180 degrees the wrong way. Simple remove it, rotate it 180 degrees, and re-install it.