Can a dirty injector cause a fuel line to stall?
Learn about the possible problems fuel injectors can cause. A dirty fuel injector can cause fuel line problems such as misfiring, hard starting, stalling and hesitation. If you are experiencing any of these symptoms, the fuel injectors may be causing the problems.
Can a fuel injector problem cause engine damage?
Fuel injectors can cause a whole host of problems that can lead to major engine damage if not diagnosed and replaced or repaired as soon as possible. To diagnose a fuel injector problem you need a keen sense of your vehicle, a little time and some basic fuel injector knowledge.
What is the code for a fuel injector failure?
If you are using a generic (not vehicle manufacturer specific) code reader; then you can expect to see codes beginning with P02. For example, a fault with an injector in cylinder one would give a code of P0201.
When to replace fuel injector seals and washers?
If the O-ring fitted to the injector is the problem; then replacing this O-ring will usually fix the leak. If the injector body; nozzle or internal components are cracked; then a new or refurbished injector is your only option. Replacement fuel injector seals and washers are cheap and are, fairly easy to install.
How many valves are in a Mercedes 190?
Since these apply to the whole system, I’m assuming it applies to all of the gasoline 190Es: 1.8, 2.0 (or was that only carbs?), 2.3, 2.6, the 16 valves, and the 3.2 AMG. The trio helped me put into order what would be most-likely-to-least-likely, but they are all possibilities.
What causes rough idle on a K Jetronic?
The movement of the control plunger will be limited if the cold control pressure is too high. This in turn will limit the amount of fuel able to be delivered through the injectors. The result will be a lean ratio and will cause rough idle. 2: Auxillary air valve defective.
Why does my Jetronic cold start injector not work?
The cold start injector will not work if the thermo time switch is defective. Check this in the event that your cold start injector does not function before replacing. (I personally was not aware of this, nor do I know where it is, but I trust them)