Can a brake job cause the ABS light?
BTW, all the fluid levels are fine and the emergency break is all the way down. 9 people found this helpful. I did have a thought some older cars and trucks offered ABS as an option and ABS versus non ABS rotors are diifferent. If the wrong rotors where uses it could trigger the ABS light, and yes it does sound mechanic related.
Why does the brake light not stay on?
BTW, the “brake” light is not on, only the “ABS” light. Look for a loose connection at the back of the hub bearings in the rear (inboard connector). There is an ABS speed sensor that sends a signal to the Antilock Brake System (ABS), you may have dislodged it or broken it by accident, Mike
Why do I need to change my brake pads?
I decided to replace the rotors, figuring turning them would be useless considering the warpage (vibration) was only felt when the brakes were hot. Figured turning the rotors while cold would not affect or eliminate the warpage. So anyhow, new Raybestos PG Plus rotors and Raybestos Quiet Stop ceramic pads did the trick…no more vibration!
What kind of brake pads do Raybestos PG plus use?
So anyhow, new Raybestos PG Plus rotors and Raybestos Quiet Stop ceramic pads did the trick…no more vibration! BTW, good thing I bought the brake caliper piston CUBE tool to screw in the piston as needle nose pliers would have taken forever, never mind possibly cutting into that rubber piston boot.
When does the ABS brake light come on?
If any of the teeth are damaged or missing, the ABS brake light will come on, warning the driver of a problem. The new style ABS systems use a magnetic encoder built into the wheel bearing, and if the wheel bearing is installed backward with the encoder facing out, it won’t take long before your ABS light is on and your stress level goes up.
What causes brake pads and rotors to get out of alignment?
As long as the piece that’s lodged in there is not removed, your rotor will eventually get damaged and will at the least need to be resurfaced and possibly replaced again. Please note that when something gets stocked in your brakes, it can even cause your brake pads to get out of alignment and cause uneven pad wear.
BTW, the “brake” light is not on, only the “ABS” light. Look for a loose connection at the back of the hub bearings in the rear (inboard connector). There is an ABS speed sensor that sends a signal to the Antilock Brake System (ABS), you may have dislodged it or broken it by accident, Mike
Do you need to replace your brake pads and rotors?
But sometimes, it is very possible to lubricate and release the stuck caliper pins. And in other cases, you need to replace the calipers completely. Also, it’s likely that you will need new brake pads and rotors. Whenever there is a brake job done on your car or replace a brake pad, you must replace the shims.