Can a ball joint be replaced on a Honda Accord?
The lower ball joints are the only units that can be replaced separately on the Accord. If you find that your Honda also needs upper ball joints, you must replace the entire upper control arm assembly.
How do you jack up a Honda Accord?
(Related Article: How to Jack Up Your Accord – Honda-Tech.com) Although you can replace the lower ball joint without removing the brakes and rotor, you may want to remove them anyway. Use the needle nose pliers to take the cotter pin out of the axle nut, then loosen the CV axle nut. Remove the lug nuts and the wheel.
How do you replace the lower ball joint?
Figure 8. The assembled lower ball joint. Replace the lower ball joint by inserting it in the steering spindle assembly, and then drawing it through the knuckle by tightening the nut. Don’t forget to install the boot before inserting the joint into the knuckle.
How do you remove axle nut on Honda Accord?
Use the needle nose pliers to take the cotter pin out of the axle nut, then loosen the CV axle nut. Remove the lug nuts and the wheel. Now you can remove the axle nut. Figure 3. Remove the axle nut. Remove the brakes and the rotor. First, remove the ABS brake sensor by removing the bolt with a 10 mm wrench.
Can you replace the lower ball joint on a Honda Accord?
Here’s how to replace the lower ball joints on a Honda Accord with double wishbone front suspension. A double wishbone front suspension consists of a coil over strut and steering knuckle tied together with upper and lower control arms. The lower ball joint on this setup is load bearing, which causes it to wear out frequently.
(Related Article: How to Jack Up Your Accord – Honda-Tech.com) Although you can replace the lower ball joint without removing the brakes and rotor, you may want to remove them anyway. Use the needle nose pliers to take the cotter pin out of the axle nut, then loosen the CV axle nut. Remove the lug nuts and the wheel.
Do you need to replace all ball joints?
Therefore, prepare to spend an entire day if you are going to do all of the ball joints. Also, realize that any other repairs like the brakes or CV joints are recommended to do as well. During replacement, the ball joints will need to pressed in. For the uppers, you can buy a control arm with a new joint in it, which adds additional cost.
What causes lower ball joint to wear out?
A double wishbone front suspension consists of a coil over strut and steering knuckle tied together with upper and lower control arms. The lower ball joint on this setup is load bearing, which causes it to wear out frequently.