Can a bad EGR valve cause high idle?

Can a bad EGR valve cause high idle?

If it were to stick open during idling the exhaust gases will reduce idling, cause rough engine running, and cause stalling tendencies. The opposite of your symptoms so it would be safe to assume that the EGR valve is not the cause of higher engine idling than normal.

Can bad ground cause high idle?

just to add, idle issues can be caused by poor grounds. if throws an offset to the voltage seen by the ECU, which either adds or pulls fuel. This either runs the engine lean or rich and the idle gets screwed up. It can result in slow cranking, unstable or low/high/surging idle, and a slew of other things.

How to troubleshoot an automotive engine high idle?

The troubleshooting procedure for high and low idle conditions are similar, which are included in the following: Step 1 – If the check engine or service engine light soon has illuminated retrieving the diagnostic trouble codes could lead you in the right direction of what the problem is, or is related too.

Is it normal to have a rough idle?

This is definitely not a normal situation. If you are experiencing a rough idle or your RPM is running high, then there are a variety of reasons for why this could be happening. It is not always easy to diagnose the cause because there are so many factors involved here. Below are the top 5 causes that a mechanic would look for.

Why does idle speed drop during cold startup?

If the idle air control valve did not compensate for these, the idle speed would drop when certain accessories are used. In severe cases, the engine may even stall. The idle air control valve is most important on a cold startup. Problems with the idle air control will be most obvious during this time.

Why does my car stop idling at 750 rpm?

It is stops idling at about 750 rpm – 1000 rpm. – emmanvazz Nov 11 ’15 at 16:00 Quite often surging like this is caused by not enough air getting passed the butterfly valve in the throttle body when the butterfly is closed. Under normal circumstances, there should be a very small gap around the butterfly to allow the air required for idle.