Are reverse lights required by law?
Reverse lights are required by law, so have a mechanic properly install the light for you to ensure everything goes smoothly.
Which fuse is for reverse lights?
The reverse light fuse (called “backup light” in the manual) is actually fused via the IG1 circuit. It’s located in the under steering wheel dash fuse box. It’s 10 amp mini blade and is the middle top location.
What is the law on reverse lights?
By law a reversing light is classed as an optional light and not an obligatory light, therefore there is no requirment to have oner at all. However it goes on to state that if you do have an optional light fitted then it must comply with regulations which merely state, 1.
How does a reversing switch work?
The drum switch is a manual switch that lets one manually reverse the direction in which a motor is turning. The switch contacts are open and closed manually by moving the drum switch from the off position to the forward or reverse position.
Is there a fuse for the backup lights?
Hi Aaron, there is a fuse in the backup lights circuit, however its not solely for the backup lights. Its fuse 20 on the junction block. But its also feeding the combination flasher and AZC, so probably is ok, at least you didn´t report any problems with that.
What to do when Your Backup lights are not working?
When the two wires are bridged together with the key on the reverse lights should work if the switch itself is defective. It is quite easy to replace, it just unscrews from the transmission if it is a stick shift, if it is an automatic transmission the switch I believe is part of the inhibitor switch and is more costly and difficult to replace.
What kind of wire does a back up light use?
Voltage to the sensor, lite blue wire with pink tracer. In reverse, black wire with pink tracer carries voltage to back-up lamps. There is also a ground for the back-up lamps, you may need to check that also. Check out the diagrams (Below).
How to check if a fuse is OK?
Start at the CU by checking all terminations then with a voltage indicator start at the fuse/MCB and check at all fittings on the affected circuit. MCB or previously loose connection somewhere between MCB and failed lamp now open circuit. if MCB is ok check continuity of L-L, N-N and E-E between CU and light fittings