Why won t my 2002 hyundai santa fe start?
While there are a variety of reasons your Hyundai Santa Fe won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
Why wont my Santa Fe start?
The most common causes that hinders normal starting operation of your Santa Fe are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.
Why does my 2010 Santa Fe not start?
2010 santa fe sometimes wont start. cranks over find but dose not start. have to try if 4 or 5 times before it starts. it is intermitant and happens every 10 or 12 starts. thanks Show More Show Less Ask Your Own Hyundai Question Share this conversation Answered in 2 hours by: 7/29/2012 Hyundai Mechanic: AMD, Master Technician replied 7 years ago
Why does my Santa Fe shut off while driving?
From the stopped position I put the car in park and tried to restart it. The car would start up fine but roughly 4-7 seconds later the car shuts off by itself again. From what I’ve been researching the Santa Fe’s have a faulty “Crank-Shaft Sensor” in which it makes the SVU just shut off while driving.
What causes a Hyundai Santa Fe to stall?
The crankshaft position sensor may fail, causing engine stalling or a failure to start. Replacement or the failed sensor will commonly correct this problem. The average cost for a Hyundai Santa Fe General Diagnosis is between $88 -$111.
How often does a crankshaft sensor throw a code?
It doesn’t do it everyday, just once in a while.To make a long story short, the “crankshaft position sensor” was bad. The sensor costs about $60 and is very easy to put in. (less than an hour) The wires rot on the sensor and touch each other causing a signal loss from the sensor. By the way; crankshaft sensors usually don’t throw a code.