Why is the voltage reading on my alternator going up?
While watching the voltmeter display, start wiggling wires at the back of the alternator, the battery, and the remote voltage regulator (if there is one). If the voltage reading on the meter display goes up while wiggling one of the wires, you’ve found a bad electrical wire or connection.
Where do you put the red lead on an alternator?
Place the red lead on the positive battery terminal (if possible dig it into the battery post, not the terminal). Place the black lead on the bad post of the alternator. Same thing as above, if the voltage is above 0.5v then examine the positive cabling for problems. Highly active question. Earn 10 reputation in order to answer this question.
What should the voltage be on a bat alternator?
Measure the voltage across the battery and the big bat alternator terminal to alternator case. There are two things that you are looking for. The charging voltage should be between 13.9v to 14.4v. Also the voltage at the battery and the voltage at the alternator should be within 0.5v of each other.
What does it mean when battery and alternator don’t match?
Also the voltage at the battery and the voltage at the alternator should be within 0.5v of each other. If the voltage at the battery and alternator don’t match. For example the battery reads 12v and alternator reads 14v. This means that there is an issue with wiring. While applying the same conditions as above.
While watching the voltmeter display, start wiggling wires at the back of the alternator, the battery, and the remote voltage regulator (if there is one). If the voltage reading on the meter display goes up while wiggling one of the wires, you’ve found a bad electrical wire or connection.
What does it mean when an alternator jump starts?
The unusual connection means when jump starting can persuade an alternator system to “see” load open circuits due to unexpected interactions. Trying to stop these happening is usually felt to be a good idea. Special regulators designed to survive such “events” are available for use in automotive equipment.
What to do if your alternator is over charging the battery?
Ask an assistant to start the engine and hold engine speed at about 1500 RPM. Measure voltage across the battery with your DMM. You should get 0.5 to 2 volts higher than base voltage. If you are getting more than 2 volts above base voltage, most likely your alternator is over-charging the battery or the battery is faulty.
What should voltage be for car battery light?
It’s relatively easy to check the function of the alternator with a multimeter. The voltage should be between 13.6 volts and 14.6 volts. If the voltage is less than 12 volts, the battery light is triggered and you’ll likely need to replace the alternator.