Why is the traction light blinking on my Subaru Forester?

Why is the traction light blinking on my Subaru Forester?

Left the Service center and went about 7 miles and the traction light, service engine light came on and the cruise control light started blinking. Returned to Service center and they found an error code for a faulty catalytic converter.

What’s the flashing engine light on a Subaru?

Guess I will be taking it to the stealership. Make sure the key was on, engine off. If it was your scanner software may not be up to date. Ive had the CEL come on with the cruise flashing. Pulled the code and found out it was the turbo wastegate solonoid malf. It happens at WOT 6k rpm or higher.

What was the problem with my Subaru Forester?

Didnt feel any difference in the drive..tried the ” turn it off and on” but lights still there…Going to drop it off at Subaru….which I wish was open later… Click to expand… so what ended up being the cause of this? i have the same model year and same problem..

Why is my cel flashing on my 2007 Subaru?

Took my 2007 with 16,000 miles to dealer when CEL and flashing cruise came on thinking it just needed to be reset. They told me I need a new catalytic converter and have ordered one.

Is the flashing cruise on a Subarus normal?

The flashing cruise is normal with any CEL on the drive-by-wire Subarus. Just get the code read & reset. i have a 2006 with the same mileage roughly and mine just did that turning onto my street tonight. so do i have to go to the dealership to reset it? being that i dont have a code reader or any idea of how to reset

How to know if your Subaru Ascent has Rab?

Click to expand… Check your gas cap. Take it off, then tighten it all the way back on, then drive for a bit and see if it turns off. Subaru is VERY safety conscious. If it detects a fault, it shuts off ALL driver assist functions, thus, your dash lights like a Christmas Tree.

Where to find check engine light code on Subaru?

When retrieving Subaru check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on.