Why is the rear cylinder not working on a Harley Davidson?

Why is the rear cylinder not working on a Harley Davidson?

Start the engine. If the rear cylinder is still the only one that is working, the ECM or ignition module is the problem. But if the front cylinder now becomes the one that is working & the rear cylinder is the dead one,,, that tells you the coil is bad. This is similar to a problem a friend is having with his 2005 Springer.

What does it mean when a Sportster backfires?

Ok, due to different terminology used by different people, I’m going to assume that by “backfire”, you mean it pops through the exhaust system when you back off the throttle.

Why is the rear cylinder not working on my Springer?

If the rear cylinder is still the only one that is working, the ECM or ignition module is the problem. But if the front cylinder now becomes the one that is working & the rear cylinder is the dead one,,, that tells you the coil is bad. This is similar to a problem a friend is having with his 2005 Springer.

What should I do if my rear cylinder is leaking?

Start the bike, take a can carb cleaner and spray the intake manifold by the head on the rear cylinder, if the bike stalls it’s leaking. A new set of gaskets will take of that. plug wires ??? If it is dropping the cylinder when getting hot, then I’d suspect either the coil or the ignition module are failing with heat.

What causes a cylinder to pop on a dual fire?

On a dual fire, wasted spark ignition, it would effect both cylinders, not just one. Suspect manifold gasket and or timing. Timing just doesn’t jump on these unless the timing plate walks. If that happens then it is off no matter what the engine temp.

Why does my rear cylinder pop when hot?

When an intake seal is bad it will cough through the carb when cold more than hot. Check the coil first. Check the resistance across the input and outputs. If it is dropping the cylinder when getting hot, then I’d suspect either the coil or the ignition module are failing with heat.

Start the bike, take a can carb cleaner and spray the intake manifold by the head on the rear cylinder, if the bike stalls it’s leaking. A new set of gaskets will take of that. plug wires ??? If it is dropping the cylinder when getting hot, then I’d suspect either the coil or the ignition module are failing with heat.