Why is the fuel tank draining on my Grizzly 450?
Just had this problem on a ~ 2010 grizzly 450 here in Aus. Fuel **** not working, evident by no reserve fuel available, fuel shut off not functioning & tank drained via the carburetor. Fuel draining continuously from the water trap/flooding overflow hose at bottom of the carby & not able to be stopped with the fuel ****.
Where are the fuel filters on a Yamaha Grizzly?
Fuel filters are inside the tank – one on normal line the other on the reserve line, part of the stop **** assembly, but to deal with this problem an inline filter is required between the problematic stop **** gasket i & the carby.
How to troubleshoot Yamaha Grizzly 700 starting problems?
While your starter problem might be something incredibly simple, you might need a new battery or a starter relay. Check out our Yamaha Grizzly 700 electrical parts diagram and starting motor parts diagram for reference.
Why is my gas gauge not working at high fuel level?
Some systems are wired so that high fuel level contacts the low-resistance section, gradually increasing resistance as fuel level drops. The system thus outputs higher voltage at high fuel level, gradually dropping voltage as fuel level drops.
Just had this problem on a ~ 2010 grizzly 450 here in Aus. Fuel **** not working, evident by no reserve fuel available, fuel shut off not functioning & tank drained via the carburetor. Fuel draining continuously from the water trap/flooding overflow hose at bottom of the carby & not able to be stopped with the fuel ****.
Why does my air filter box have gas in it?
So the other day I went to clean my K&N filter after riding, and when I opened the lid to the air filter box, I smelled very concentrated gas fumes. As I took the filter out, I noticed the filter itself was damp with gas also. At the bottom of the box, I could see dark outlines of where the gas had been, but was now evaporated.
Fuel filters are inside the tank – one on normal line the other on the reserve line, part of the stop **** assembly, but to deal with this problem an inline filter is required between the problematic stop **** gasket i & the carby.
What causes engine oil to blow by into the air filter box?
If any cylinder tests low squirt a small amount of oil or transmission fluid into the corresponding spark plug hole and perform the test again. If the compression raises after applying oil then the piston ring for that cylinder is bad and is likely the cause of the oil blow-by. Repairing Internal Problems