Why is the back of my toilet tank leaking?
This should stop the leak, but if it doesn’t – it is about time to purchase for a new gasket. When leakage is coming from the back of the tank (usually near the top of it), it is highly likely the refill tube on the tank has come loose.
How do you remove a fuel tank sending unit?
Most fuel tank sending units are held in place with a lock ring, which is rotated counter-clockwise to loosen. While there are special tools designed to perform this job, you usually can accomplish the removal with a pair of groove-joint pliers, or a hammer and drift. In either case, be certain not to damage components.
How to remove the locking ring on a Harley Davidson?
Using a hammer and punch (or similar blunt object), tap the locking ring tabs in a counter-clockwise direction to free the locking ring. Similarly, a locking ring removal tool can be used if available. Figure 21. Locking ring removal.
Is there a leak between the tank and Bowl?
The colored water will show leakages between tank and bowl in minutes. Yet, there are different levels of damage here. For instance, leakage coming from the near center between the tank and bowl means you would probably have to purchase new washers for the bolts or a new sponge gasket for the tank-to-bowl area.
How to install lock ring on fuel tank?
The OEMTOOLS Fuel Tank Lock Ring Tool makes it easy to install and remove the lock ring on your fuel tank as you service the fuel pump. This lock ring tool is compatible with many Ford, Chrysler, and GM vehicles. And our simple-to-use lock ring tool gets the job done in just a few steps without requiring a lot of tools.
Which is the best fuel tank lock tool?
Its Black Oxide Finish is good in resisting rust. Sunluway fuel sender tank lock ring tool will help tackle the job of replacing the fuel sender FAST and EFFECTIVE without damaging the rings 100% SATISFACTION GUARANTEE: We are serious to offer the best products and services to customers.
Is there a way to change the fuel pump ring?
Be sure to thoroughly vacuum all dust from the ring area before unlocking it, or debris will fall into the gas tank. It took a 4-ft long pipe on my breaker bar and a little oil on each locking tang, to rotate the ring. Replacing the sensor was the easiest task, and now I know how to replace the fuel pump, too.
What kind of steel is a fuel pump lock ring made of?
A MUST HAVE TOOL: Made of High Standard Structural 42CrMo Steel with good mechanical properties, our tool is solid enough. Its Black Oxide Finish is good in resisting rust.