Why is the ABS light on on my Hino Van?
I scanned a Hino cube van for an ABS light being on for a friend of mine. I was able to read it with Wabco. The code says, “Retarder output pin not connected to load. Load was once detected or SAE message missing, but was once recieved”.
How many times does a Hino lamp flash?
For example, the lamp flashes 1 time, then a pause of 1.5 seconds, then flashes 3 times. This means code 13. 7. If two or more fault codes are stored in the memory of the electronic unit, the codes will be separated by a pause of 2.5 seconds. 8. If there are no faults, the test lamp should flash at an interval of 0.26 seconds.
How is the fault code of a Hino truck determined?
5. The malfunction code is determined by the series of outbreaks “tens-units” of the warning lamp. 6. For example, the lamp flashes 1 time, then a pause of 1.5 seconds, then flashes 3 times. This means code 13. 7. If two or more fault codes are stored in the memory of the electronic unit, the codes will be separated by a pause of 2.5 seconds.
When is there no Ne signal on a Hino truck?
There is no “NE” signal to the electronic control unit for 2 seconds or more when the crankshaft is cranked by the starter. 1. Open or short circuit in the sensor circuit of the shaft speed sensor pump.
What does the code say on a Hino truck?
The code says, “Retarder output pin not connected to load. Load was once detected or SAE message missing, but was once recieved”. This little truck doesn’t have a drive line retarder, engine brake, exhaust brake, etc. It’s just a 10 tonne cube van. There is no more info in Wabco Toolbox, and no troubleshooting steps.
What are the five groups of Hino parts?
HINO uses five major groups. Engine – Electrical – Drive – Cab Rear Body and Chassis/Tool The sixth column is the FIGURE #that the part can be found in the Hino Electronic Parts Catalog and is helpful if you need other parts in addition to what’s listed in the Quick Reference Guide. See the example shown above from the EPC.
Which is the fifth column in Hino Quick Reference Guide?
The fifth column is the GROUP. HINO uses five major groups. Engine – Electrical – Drive – Cab Rear Body and Chassis/Tool The sixth column is the FIGURE #that the part can be found in the Hino Electronic Parts Catalog and is helpful if you need other parts in addition to what’s listed in the Quick Reference Guide.