Why is my motorcycle clutch lever sticking?
Check if the cable can freely and easily move in the casing, if not then: It’s very likely either dirty, lacking lubrication or too old, brittle and therefore sticks. It’s the easiest and cheapest approach. If not the cable then take it to a mechanic because it will be a much more complex problem.
Why are my gears stuck bike?
If you find you’re skipping a gear or that your shifting is getting stuck, then there’s a good chance you need to adjust your indexing. Indexing problems can be caused by cable stretch, which is a normal part of the bedding-in process for new bikes or cables.
Why does my motorcycle clutch not shift gears?
If you can’t get the motorcycle to shift into certain gears and your gear shift lever by your foot just goes up and down freely, your clutch is bad. This is due to the clutch being stuck or seized altogether which in turn doesn’t let you change gears.
How can you tell if your clutch is bad on a motorcycle?
If they get stuck apart, your gears aren’t going to lock together and you won’t be able to get it in gear. Another sign to look for is if your gear shifts are hard. This means you hear an unpleasant clunking sound and may even feel a bit of a jerk coming from the bike when you are shifting during a ride.
Is it possible to get transmission stuck in gear?
Yes you can do this without pulling the motor, you have to pull the cover, clutch and clutch basket and primary drive gear. I will actually be doing this over the weekend and will take pics and post the up as I go, I wont be pulling the motor to do mine.
Why is my Clutch not working on my car?
An old, worn or dirty clutch cable is one reason. Other factors include dirty lever, stiff clutch springs, dirty or worn actuator arm or push rod. Clutch position and hand strength can also be a factor.
What’s the best way to position the clutch?
Position your clutch lever so that your wrist is in a flat, neutral position when you reach for the lever. This will give you the most grip strength and reduce hand fatigue. Another option is to move the lever an inch or two closer to the center of your handle bars.
Why is my clutch lever so stiff on my motorcycle?
Stiffness in the lever can sometimes be caused by sticky grease and dirt at the pivot point, as well as worn bearings. Remove the lever and clean and inspect all the contact points include the screw. If your lever has a bearing, check to make sure it spins smoothly.
What should I do about my Clutch on my motorcycle?
Part of your annual maintenance should include inspection and lubrication of the clutch cable. Start by inspecting the clutch at the point where it connects to the clutch lever and to the actuator arm.
An old, worn or dirty clutch cable is one reason. Other factors include dirty lever, stiff clutch springs, dirty or worn actuator arm or push rod. Clutch position and hand strength can also be a factor.