Why is my Honda Accord p1259 not working?

This is facilitated by sending oil into the VTEC system, which changes the engine timing. A good rule of thumb is that if the P1259 code sets at 4000 RPM or below, it’s usually the VTEC pressure switch wiring issue or bad switch. If it is set at 4000 RPM or greater, it’ll usually be an oil related issue.

What does OBD 2 fault code p1259 mean?

What Does Code P1259 Mean? OBD II fault code P1259 is a manufacturer specific code that is defined by carmaker Honda as “VTEC System Circuit Fault (Bank 1)”, and is set on these applications when the PCM (Powertrain Control Module) detects a defect, malfunction, or failure in the electrical control/monitoring system of the VTEC mechanism on Bank 1.

Where is the p1259 sensor located on a Honda Civic?

It should be noted though while that code P1259 specifically refers to a problem in the VTEC systems’ control/signal/monitoring circuit, some mechanical failure modes can contribute to this code being set and stored. Where is the P1259 sensor located? The image above shows the location of the VTEC oil control solenoid on a Honda Civic engine.

How much does it cost to diagnose the p1259 Honda code?

What does this mean? The cost of diagnosing the P1259 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P1259 HONDA code detected?

What does check engine code p1259 mean?

P1259 is a code for vtec malfunction usually cause by a bad vtec solenoid, vtec pressure sensor, low oil level, bad connection.

What does a p1259 code mean?

Error Code P1259 is defined as VTEC System Malfunction. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes. Rather, it applies only to specific vehicle makes, such as Honda, Acura, etc. Specification of the definition, troubleshooting, and repairs still vary from one make and model to another.

What is a civic p1259 check engine code?

In the Honda Civic, P1259 means that there is a malfunction in the VTEC system. It is a manufacturer specific code, which means that it means the same thing for all vehicles manufactured by Honda. The VTEC system is an integral part of your Civic’s engine It stands for Variable Valve Timing and Lift Electronic Control System.

Where is the VTEC system malfunction code p1259?

Re: VTEC System Malfunction code P1259 has appeared. (… Check your variable valve timing oil pressure switch, it’s located on the passanger side just before the intake manifold, also the solenoid may be dirty or bad. some people say to clean the screen but that requires removing the entire assembly where these two units are… Good luck

What’s the code for Honda Accord system malfunction?

I have a 99 Honda accord I put it in machine it says the code is P1259Vtec System malfunction.. I have had oil changed, New spark plugs,New Fuses,Oil Filter,Oil treatment,Oil system cleaner,Oil pressure switch,Air Intake system Cleaner,replaced Sender Unit. Went to Get Smogged and It passed EVERYTHiNG Except check engine light…

What does it mean when your Honda Accord says p1259?

P1259 specifically means that there is an issue with the VTEC circuit itself. Although, mechanical issues can cause the code to register as well. If you are unsure of the oil weight used in your Accord’s last oil change, this would be a great place to start.

How much does it cost to repair a Honda p1259?

The cost of diagnosing the P1259 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

What to look for on a Honda Civic p1259?

Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P1259 HONDA code is 1.0 hour of labor.

How much does it cost to diagnose Honda code p1259?

The cost of diagnosing the P1259 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P1259 HONDA code detected?

What causes a Honda VTEC code p1259?

Nonetheless, some other common causes of code P1259 could include the following- Failed or failing PCM, but note that since this a rare event, the fault must be sought elsewhere before any control module is replaced

What is the trouble code for Honda VTEC?

P1259 – VTEC system malfunction (Honda) Trouble Code Fault Location Probable Cause P1259 VTEC system malfunction Wiring, VTEC solenoid/pressure switch, E

What is the code for Honda Accord LX engine malfunction?

I have a 1998 honda accord lx that is having this same problem. check engine light cames on a long time ago so i had a diagnostic ran on it and got the code p1259. i was having my oil changed at the same time this was discovered. i am a woman and in no way mechanically inclined. what should i do? (cheap solution if possible)

What is the p1259 code on a Honda CRV?

Vocational, Technical or Tra… Honda Crv: 2002 Honda CRV has code p1259. Cars engine will 2002 Honda CRV has code p1259. Cars engine will not run past 2500 rpm’s starts to cut out and will not accelerate. … read more Vocational, Technical or Tra… Automotive Repair/Damage… Former ASE Master Techni… Vocational, Technical or Tra…

How much does it cost to repair a p1259 Honda?

An error occurred while retrieving sharing information. Please try again later. What does this mean? The cost of diagnosing the P1259 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When do I get an error code p1259?

Error Code P1259 is detected when there is a problem in the VTEC oil pressure switch or at the VTEC solenoid valve circuit. As with other error codes, Error Code P1259 activates the Check Engine light and registers the code to the vehicle’s memory system.

What is the VTEC oil pressure switch error code p1259?

Error Code P1259 is detected when there is a problem in the VTEC oil pressure switch or at the VTEC solenoid valve circuit. Common Symptoms. As with other error codes, Error Code P1259 activates the Check Engine light and registers the code to the vehicle’s memory system.

What does p1259 failure mean?

Code P1259 is for a VTEC system failure. This is usually caused by low engine oil…….the VTEC system runs off oil pressure and if the oil is low this code will set.

How does the VTEC system work on a Honda Accord?

The VTEC system controls the valve timing in your Honda. It does this by activating the VTEC/Rocker arm solenoid. It uses the Rocker Arm oil pressure switch to monitor the pressure of this system. P1259 specifically means that there is an issue with the VTEC circuit itself. Although, mechanical issues can cause the code to register as well.

Navigation