Why is my engine not working on my Jeep Liberty?
Reports indicate that the original Chrysler engine design has valve seats that are pressed into the cylinder heads. The issue comes about when the powdered metal the valve seats are constructed of- enlarges or expands. This causes a drop into contact with the valve as well as the Jeep’s pistons.
Why are the valve guides on my Jeep Liberty going bad?
The story from the mechanic it is that due to some carbon build up and it has caused the valve guides to go bad. He also stated that not driving it enough can be a cause for the carbon build up. He also found that one of the timing chain guides had broken . . on the right side.
What is the code on my Jeep Liberty?
Code indicated a misfire in the #2 cylinder. Am taking it to a mechanic today to have it checked. When engine is first turned on sounds fantastic.
Is there a problem with my 2005 Jeep Liberty?
So, $3100 later it is time to say goodbye to the Liberty I have a 2005 Jeep Liberty with the 3.7 V6. Heads have been pulled off, sent to machine shop, checked ok. Pulled piston on the cylinder that misfires, replaced rings, checked compression after reinstallation of heads.
Reports indicate that the original Chrysler engine design has valve seats that are pressed into the cylinder heads. The issue comes about when the powdered metal the valve seats are constructed of- enlarges or expands. This causes a drop into contact with the valve as well as the Jeep’s pistons.
The story from the mechanic it is that due to some carbon build up and it has caused the valve guides to go bad. He also stated that not driving it enough can be a cause for the carbon build up. He also found that one of the timing chain guides had broken . . on the right side.
So, $3100 later it is time to say goodbye to the Liberty I have a 2005 Jeep Liberty with the 3.7 V6. Heads have been pulled off, sent to machine shop, checked ok. Pulled piston on the cylinder that misfires, replaced rings, checked compression after reinstallation of heads.
Code indicated a misfire in the #2 cylinder. Am taking it to a mechanic today to have it checked. When engine is first turned on sounds fantastic.
Are there any problems with the Jeep Liberty 3.7 engine?
According to one leading engine builder, Chrysler’s 3.7-liter engine has some fatal flaws. The engine builder also adds that if not attended to, there could be some serious as well as catastrophic vehicle failures just after the warranty expires.
What happens if you don’t clean your intake valve?
By not cleaning it, more than likely those pieces will be sucked back down into the engine and you might wind up doing it all again, ughhh. If you have any questions about this or any topic (no marriage counseling) please call us anytime, 407-730-9777.
What causes a fluid leak in a Jeep Liberty?
Owners of some 2002-2012 Jeep Libertys have reported fluid leaks from their vehicles caused by a worn differential pinion seal or transfer case. These leaks can cause bearing failure, which may lead to excessive vehicle vibration and whining or grinding noises.
Why does my Jeep Liberty engine misfire at idle?
An engine misfire at idle (rough idle), accompanied by illumination or flashing of the check engine light, could indicate a problem with one or more of the intake valves. Revised intake valves & valve locks are available to address this concern.
What should I do about my Jeep Liberty water pump?
They have put in 6 new spark plugs, a new serpentine belt tensioner, performed a two part valve and induction system cleaning, installed a new water pump and finally did a valve job on it. They just completed installation of 12 new valves and keepers. Thankfully all this work was performed under warranty.
What kind of problem does a Jeep Liberty have?
Check engine light on. Extreme shaking when idling. Fine once it gets going. Jeep suddenly would not start unless you aggressively apply the accelerator and maintain above 1500 RPM, it would not idle, and reported a P0306 diagnostic code (Cylinder 6 misfire). FYI the last digit is the cylinder # so you may see a different P030X.
What is the tipm on a Jeep Liberty?
The TIPM is what Chrysler called the total integrated power module, a kind of electronic brain for many years of their vehicle models for a number of years. Unfortunately, the TIPM was riddled with issues no matter what model they were put in and routinely malfunctioned.
When did Jeep stop making the Jeep Liberty?
When it was replaced in 2012, the Jeep Cherokee took over. The Cherokee had been what the Liberty was called in markets outside of North America. Arguably that means the Liberty is still in production, but now it is just known as the Jeep Cherokee.
What kind of engine does a Jeep Liberty have?
The 3.7 replaced the 2.5 liter four-cylinder, and then went on to replace the 3.9-liter V6 engine- which were both used only on Jeeps and Chrysler trucks. The 3.7’s first use was only an option for the Jeep Liberty. As more of a “car-like” engine, the 3.7 engine offered a 210 horsepower at 5,200 rpm, with 235 lb.-ft of torque at 4,000 rpm.
The TIPM is what Chrysler called the total integrated power module, a kind of electronic brain for many years of their vehicle models for a number of years. Unfortunately, the TIPM was riddled with issues no matter what model they were put in and routinely malfunctioned.
When it was replaced in 2012, the Jeep Cherokee took over. The Cherokee had been what the Liberty was called in markets outside of North America. Arguably that means the Liberty is still in production, but now it is just known as the Jeep Cherokee.
Are there any problems with the 2003 Jeep Liberty?
2003 Jeep Liberty Problems In 2003 one of the main issues relating to problems with a 2003 Liberty was the lower ball joints in the front suspension. The NHTSA logs hundreds of complaints about this and there is reportedly one death related to it as well.
Are there any recalls on the Jeep Liberty?
There were 10 recalls issues that affected the 2006 year. Again, the lower control arm fractures in the we are impact fire damage were covered as well as the lower ball joints. There was another recall that affected just under 150,000 Vehicles related to overheating ventilators and AC blower motors.
When did the Jeep Liberty KJ come out?
There are two versions of the Liberty. The KJ series which was produced from 2002 to 2004, and the KK series introduced in 2005 to the present. There are four wheel drive models and two wheel drive models.
How to troubleshoot a Jeep Liberty’s transmission?
The main drive gear bearing or countershaft also may be damaged. Check for noise in a particular gear. This indicates worn, damaged or chipped gear teeth. The synchronizer for the gear may also be worn or damaged. Drive the vehicle and check for slippage in high gears.
What causes gears to chatter in Jeep Liberty?
Insufficient gear oil due to a leak can cause the gears to chatter. Check the transmission oil seal or vehicle speed sensor O-ring. Drive the vehicle and check for gear slippage, noise or no drive in forward or reverse gears. Lack of automatic transmission fluid can cause these issues.