Why does the flame keep going out on my furnace?
If you are trying to light a standing pilot light on an old furnace but it keeps going out, make sure you are holding the pilot button long enough. This gives the flame enough time to heat the flame sensor (thermocouple) that tells your furnace it’s OK to light the burner.
Why does my furnace keep shutting off after a few seconds?
If your furnace shuts off too often, you could have a corroded or dirty flame sensor. If the flame sensor is dirty or has become corroded, the flame won’t register and will turn off the gas valve, which, in turn, causes your system to shut down.
How do you know if a flame sensor is bad?
How do I know if my furnace flame sensor is bad?
- Switch off the power to your furnace.
- Close the gas valve.
- Take out the mounting screw.
- Carefully pull out the sensor.
- Inspect the sensor: if the insulation is intact but appears sooty, burnt or slightly corroded, it might only require cleaning.
Why does my furnace blower keeps turning on and off?
If your blower is constantly turning on/off when the furnace isn’t heating… …you most likely have a bad fan limit switch. So if your furnace blower is turning on and off when the furnace isn’t in a heat cycle, it usually means the fan limit switch is defective.
Why does my heat not stay on?
Dirty filters are the most common cause of furnace problems. Dust and dirt restrict airflow—and if the filter gets too clogged, the heat exchanger will overheat and shut off too quickly, and your house won’t warm up. If the blower is running but no heat is coming out, replace the filter.
How do you turn on the Atwood Hydro Flame furnace?
How to Light an Atwood Hydro-Flame Furnace
- Charge your RV’s battery up and turn the Atwood Hydro-Flame furnace’s gas valve on to the “pilot” position.
- Light a match while pushing and holding the gas valve.
- Allow the gas flame to burn for a moment before switching the gas valve over to the “on” position.
What happens if my Atwood flame furnace stops working?
That means if you fail to get the RV furnace back to work, it would get very cold later tonight. In the case you don’t want to get sick due to low temperatures, this troubleshooting guide is for you. Everything you need to know Atwood hydro flame furnace including working principles, problem symptoms and more are presented downs below.
Why does my furnace burner not stay lit?
It comes on and the burner ignites but it won’t stay lit. It “attempts” to light the death, turn it off, or the battery runs down). wheel etc. I found that the blower housing had a missing screw which would cause low static pressure. I replaced the screw and the furnace worked fine–for a while. Then it started doing it’s thing again.
Why is the igniter on my hydro furnace not working?
If the battery is depleted, the control circuit board would not be able to transmit orders to the control circuit board due to energy shortage. As a result, the valve and the igniter remain inactive. For most of the time, you could determine whether the RV battery is consistently providing juice to the furnace or not by using the multimeter.
What happens when you set the thermostat on a furnace?
For most of the time, once you set the thermostat, the blower motor and the control circuit board of the furnace would kick into action. While the blower motor and fans produce an air stream, the control circuit board would open the gas valve and make the igniter generate sparks.