Why does my Santa Fe y2006 not start?
Hello, my Santa Fe Y2006 has this same problem. New glow plugs, currently changed crankshaft position sensor, battery in good condition, starter spins perfectly but no starting when cold (in the morning). Possible to start only after spraying of starting fluid directly to air filter outlet. Once started it will run all day with no problems.
Why does my 6.5 Turbo Diesel not start?
Please try again later. 6.5 turbo diesel no start, we will see how easy it is to jump the glow plug relay and start the truck at any time we want. Diesel engines need the glow plugs to be nice and hot so the engine would be able to start. Thanks for watching this video. I hope this was a helpful one. God bless and we will see you in the next one.
Where is the fuel cutoff switch on a Hyundai Santa Fe?
checkingthe crank sensor is a good idea but there is also a fuel cutoff switch under the hood that may have been tripped. its along one of the fenders ( i tink the drivers side. doesnt happen often byt its another thing to check. if its tripped it will click when pressed (theres a little button on top of it) 82 people found this helpful.
Why does my car not start when I crank the engine?
If the engine doesn’t crank, or makes an unusual noise when cranking, you may have a starting system problem. The car’s security system may have made an error that disabled the fuel or ignition system, or the chip in the key may have failed.
Hello, my Santa Fe Y2006 has this same problem. New glow plugs, currently changed crankshaft position sensor, battery in good condition, starter spins perfectly but no starting when cold (in the morning). Possible to start only after spraying of starting fluid directly to air filter outlet. Once started it will run all day with no problems.
Please try again later. 6.5 turbo diesel no start, we will see how easy it is to jump the glow plug relay and start the truck at any time we want. Diesel engines need the glow plugs to be nice and hot so the engine would be able to start. Thanks for watching this video. I hope this was a helpful one. God bless and we will see you in the next one.
Do you use starting fluid on a crank no start?
AAAhhh do not use starting fluid on a hard start. If you have only 3 glow plugs working and you use starting fluid on it you are going to cause engine damage very quickly. These are just a few 7.3 Power Stroke problems issues to keep in mind on a crank no start.
What causes a crank no start 7.3 Power Stroke?
If you have only 3 glow plugs working and you use starting fluid on it you are going to cause engine damage very quickly. These are just a few 7.3 Power Stroke problems issues to keep in mind on a crank no start.
Why is the starter clicking on my Hyundai?
If the starter is clicking on your Hyundai, it could be the battery, or it may be the starter itself. The best-case scenario is that it’s the battery, but even if it is the starter, don’t despair. Even an inexperienced person can change the starter out in about 90 minutes.
What to do if your starter won’t start?
Put the new starter on the engine and tighten the mounting bolts with the socket and ratchet. Reconnect the electrical wires, tightening the nuts with the wrench, and then plug in the wiring harness.
Is there a no start, no crank Jeep Wrangler?
2004 JEEP WRANGLER SPORT 4.0L I6 Was working on this 04 Jeep and it had a no start, no crank condition. Checked all the fuses, power and ground wires on the starter, engine and body but, found the wires were all properly connected and the fuses were okay. The battery was fully charged.
2004 JEEP WRANGLER SPORT 4.0L I6 Was working on this 04 Jeep and it had a no start, no crank condition. Checked all the fuses, power and ground wires on the starter, engine and body but, found the wires were all properly connected and the fuses were okay. The battery was fully charged.
What causes a car starter to go bad?
A variety of problems can lead to a bad starter, including: 1 Loose wiring to and from the starter 2 Dirty connections 3 Battery corrosion 4 Damaged or worn-out parts in the starter system 5 Oil leaks More
Where does the starter go in a car?
The starter is a small motor, powered by the battery. It gets the engine of your car running. A starter relay sits between the battery and the starter motor, transmitting power.
What is the code for the Hyundai Santa Fe?
The code in the computer after failure should be P1690 or P1693 (or both). After changing the antenna piece near the ignition (180$ at the dealer), the icon shows up and car starts every time…. been around 50 times to far and no issues. Hope this helps 64 people found this helpful. this sounds so similar to whats happening with our 02 santa fe.
checkingthe crank sensor is a good idea but there is also a fuel cutoff switch under the hood that may have been tripped. its along one of the fenders ( i tink the drivers side. doesnt happen often byt its another thing to check. if its tripped it will click when pressed (theres a little button on top of it) 82 people found this helpful.
The code in the computer after failure should be P1690 or P1693 (or both). After changing the antenna piece near the ignition (180$ at the dealer), the icon shows up and car starts every time…. been around 50 times to far and no issues. Hope this helps 64 people found this helpful. this sounds so similar to whats happening with our 02 santa fe.
Where is the Master Lock on a car?
Power locks are convenient, and the master lock control on the driver side allows you to lock and unlock all the doors in the car. Here’s how to use it: Press the end of the switch with the closed…
What does it mean when your steering wheel is locked?
Steering wheels lock in position as part of a vehicle’s safety features. The main purpose of a locked wheel is to prevent vehicle movement when there is no key, or if the wrong key is inserted into the ignition.
What to do if the tailgate won’t lock on my Santa Fe?
There is a small plate on the tailgate door about center and a little to the right about2x3 inches. remove it and with your finger reach in through the insulation and you will feel a lever. that is the manual release. if it will not move the control motor is broken in the locked position.
What’s the cost of a Hyundai Santa Fe power door lock?
Hyundai Santa Fe Power door locks are not working Inspection costs $85 on average. Power door locks are the most important security element of your vehicle. They keep potential thieves and burglars out of your car, and make it easy for you to lock and unlock your doors in a hurry.
What to do if your Hyundai Santa Fe is stuck in Park?
The engine is running fine, but the shifter just won’t move. There are several things you can try to get your Hyundai Santa Fe moving now. These include checking to see if the parking brake is stuck, finding the shift lock solenoid override (if applicable), and the shift linkage. Let’s get straight to it.
What to do if your power door lock is not working?
Hyundai Santa Fe Power door locks are not working Inspection at your home or office. Our certified mobile mechanics can come to you now. Hyundai Santa Fe Power door locks are not working Inspection costs $89 on average. Power door locks are the most important security element of your vehicle.