Why does my quad click but not start?
The number one reason an ATV clicks and doesn’t start is the battery, so you should troubleshoot that first. If your battery is functioning correctly, the next common source is the starter solenoid or a bad starter motor. Occasionally you could have hydro-locked your engine, or the fuses have failed.
How to start an ATV that wont start?
1 Remove the spark plug from the cylinder-head and connect it to the spark-plug wire or ignition coil. 2 Grab the plug wire and hold the plug about 1/8th of an inch away from the cylinder head. 3 Activate the starter. 4 As the motor turns, you should see repetitive bright blue spark arching from the spark plug to the cylinder head.
Where is the solenoid on an ATV starter?
The solenoid is usually located near or on the starter. Put your multimeter to DC Voltage. The red lead goes to the battery (red) side of the solenoid. The black lead goes to ground. You should get a voltage reading of 12V or more.
Why is my ATV not getting a spark?
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.
Why is my fuel pump not working on my ATV?
Troubleshoot a fuel pump that is not working ATVs with traditional carburetors usually have a vacuum-operated fuel pump. They are run by vacuum/pressure pulses created in the crankcase. The negative pressure pulls fuel in, while positive pressure pushes fuel out. Locate the pump by tracing the line coming from the gas tank.
What does it mean when your ATV won’t start?
The solenoid should make an audible “clicking” sound each time you hit the starter. If it does, you know it is getting power, and the problem is likely with the solenoid itself or possibly the starter.
The solenoid is usually located near or on the starter. Put your multimeter to DC Voltage. The red lead goes to the battery (red) side of the solenoid. The black lead goes to ground. You should get a voltage reading of 12V or more.
Troubleshoot a fuel pump that is not working ATVs with traditional carburetors usually have a vacuum-operated fuel pump. They are run by vacuum/pressure pulses created in the crankcase. The negative pressure pulls fuel in, while positive pressure pushes fuel out. Locate the pump by tracing the line coming from the gas tank.