Why does my Mercedes C240 engine not start?

Why does my Mercedes C240 engine not start?

The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor. The average cost for a Mercedes-Benz C240 No Start Diagnosis is between $143 -$180.

What was the problem with my C240 in 2003?

2003, C240, 1 owner, car stalls, cools down and restarts and runs for about 15 minutes, then stalls. Replaced fuel filter and fuel pump; problem persists! Also, checked battery and alternator (both were o k) after 1’st stall episode.

What happens if the crank on a Mercedes Benz goes bad?

Symptoms of a defective crankshaft position sensor on a Mercedes-Benz. Failed crankshaft position sensor can also impact the idling, the acceleration, or even your transmission shifting. In some cases, it can cause your transmission to go into limp mode. You may also notice an increase in engine vibrations.

What causes a Mercedes Benz to stall and not start?

Symptoms of a defective crankshaft position sensor on a Mercedes-Benz. Engine Cranks but no Start, Dies, Stalls, or Backfires. A failed crankshaft position sensor can cause your engine to stall or not start at all. Your Mercedes-Benz may start and run for a short time, or until it gets warm and then it dies.

The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor. The average cost for a Mercedes-Benz C240 No Start Diagnosis is between $143 -$180.

2003, C240, 1 owner, car stalls, cools down and restarts and runs for about 15 minutes, then stalls. Replaced fuel filter and fuel pump; problem persists! Also, checked battery and alternator (both were o k) after 1’st stall episode.

Symptoms of a defective crankshaft position sensor on a Mercedes-Benz. Failed crankshaft position sensor can also impact the idling, the acceleration, or even your transmission shifting. In some cases, it can cause your transmission to go into limp mode. You may also notice an increase in engine vibrations.

Symptoms of a defective crankshaft position sensor on a Mercedes-Benz. Engine Cranks but no Start, Dies, Stalls, or Backfires. A failed crankshaft position sensor can cause your engine to stall or not start at all. Your Mercedes-Benz may start and run for a short time, or until it gets warm and then it dies.

Why does my Mercedes not start in cold weather?

When I park it in my heated garage over night, it starts a little easier in the morning, but still hesitates a little. When I leave it over night outside in cold weather, the car keeps cranking in the morning with no sign of firing up.

Why does my 07 C230 not start in cold weather?

The fuel pump could be weak or you could have a fuel line leak due to shrinking seals in cold weather. have you ever found the source to your cold starts problem? I have 07 c230 flex with 62k miles as well and my car started having exactly the same symptoms just like yours.

What are the symptoms of a bad engine control module?

1. Check Engine Light Turns On 2. Engine Stalling or Misfiring 3. Engine Performance Issues 4. Car Not Starting 5. Poor Fuel Economy The engine control module (ECM), also commonly referred to as the engine control unit (ECU) or powertrain control module (PCM), is one of the most important components found on virtually all modern vehicles.

Can a bad ECM cause a car to stall?

Engine Stalling or Misfiring Erratic engine behavior may also indicate a bad or failing ECM. A faulty computer may cause the vehicle to intermittently stall or misfire. The symptoms might come and go and not appear to have any sort of pattern to their frequency or severity. 3. Engine Performance Issues

1. Check Engine Light Turns On 2. Engine Stalling or Misfiring 3. Engine Performance Issues 4. Car Not Starting 5. Poor Fuel Economy The engine control module (ECM), also commonly referred to as the engine control unit (ECU) or powertrain control module (PCM), is one of the most important components found on virtually all modern vehicles.

Engine Stalling or Misfiring Erratic engine behavior may also indicate a bad or failing ECM. A faulty computer may cause the vehicle to intermittently stall or misfire. The symptoms might come and go and not appear to have any sort of pattern to their frequency or severity. 3. Engine Performance Issues