Why does my Harley Davidson have no power?

Last Friday I shut the motor off with the stop switch and then turned the ignition key off. I re-set the stop switch to On. 1 minute later, I turned the ignition switch to ignition and noticed I had no power to my headlights and instrument lights.

Why is there no power when the key is turned?

When that dead/dying battery was in place, the lights would power on dimly while the key was on, and I would hear a clicking sound while trying to start it, but it would not turn over. The battery was tested and needed to be replaced. Now, with a new battery that has been tested to be good, I don’t get any electrical power when turning the key.

What should I do if there is no power to the ignition?

1) Battery is good. 2) Battery cables and connections are good. 3) Stop or kill switch was taken apart and tested. 4) Circuit breakers for ignition, instruments, lights, accessories, and main breaker were tested for continuity. 5) Continuity of wires from ignition switch to main breaker were tested.

Why does my ATV have no power when I turn the key?

When I installed the new battery, I didn’t noticed that there were two positive cables that need to be connected to the positive terminal. One of them had slipped back into the boot, and I only connected the other one. This is why the ATV had no power at all when I was turning the key.

Why does my Harley Davidson run weird after a charge?

The reason its intermittent is the bike will start running weird in other words it would take a charge but if for some reason that charge did not hold for long the bike will start running weird again. So I went and change the battery and I’ve never had the problem since.

Is there a problem with my Sportster 1200 XLH?

Before I go out and buy parts I think I need, maybe somebody can jump in and pinpoint the problem. 1995 Sportster 1200 XLH. Ride it daily to work. Last Friday I shut the motor off with the stop switch and then turned the ignition key off.

Why does my Mazda MPV LX not start?

My Mazda MPV LX (2000) is doing the same thing. Starts most of the time, then after a few days or a week, after a short stop, it won’t start. Alternator was changed 6 months ago. New battery after the first non- start, new Neutral Safety Switch, too. Still didn’t help.

What should I do if my Harley loses all power?

Cart LOG IN Become A Member Become A MemberJoin VideosVideos COL1 Recent Videos Free Videos Member Videos Maintenance – Videos Milwaukee Eight Touring Touring – Twin Cam, Evo Trike – Twin Cam Milwaukee Eight Softail Softail & Dyna – Twin Cam, Evo

How many volts does a Harley Davidson need to start?

10 volts is not sufficient voltage to start a Harley Davidson. If you loose everything when you turn your ignition switch to the 2nd position, you either have a bad switch or a dead short. Why was the voltage regulator changed? Was the charging system tested? Have more questions?

Why is the start button not working on my Harley Davidson?

If you did NOT read 12 volts, you would have to go back to the TSSM and hot wire (bypass it) in order to determine where the problem was. Also testing the start button would be something to check also. The key point to remember is that the “Start Relay Control” comes from the TSSM.

How to turn off the FOB on a Harley Davidson?

Here’s how to do it!! 1. Select 5 digit code ( each digit being a 1 thru 9) and record it on the wallet card in the owners manual. 2. With an assigned FOB present, turn IGN key ON – OFF – ON – OFF – ON 3. Press Left turn signal switch 2 times. 4. Press Right turn signal switch one time and release.

What happens if you have a bad voltage regulator on a Harley?

If there is anything wrong with the voltage regulator of your precious Harley, you will notice some unusual behaviors from the bike as follows – As I mentioned earlier, a bad regulator cannot control the voltage, which overcharges the battery. When the battery gets overcharged regularly, it causes the gas to escape from it.

Are there any problems with a Harley Davidson battery?

Harley Davidson Voltage Regulator Problems – Not To Worry ! It’s not new for a Harley Davidson bike to experience electrical problems. Your Harley can have an issue with the battery and voltage regulator, which isn’t a big deal.

What to do if your Harley Davidson won’t start?

Get (2) 12″ pieces of wire and stripe 1/2″ from each end. Insert 1 wire into the female terminal that would be #30 in the fuse panel socket. Insert the other WIRE (NOT END of 1st wire) into #87 of the fuse panel socket. 6) Make SURE bike is in NEUTRAL. 7) Turn on ignition ON and Kill switch to run.

Why are my lights not working on my Harley?

your bike will not start because you have no IGNITION power. the ignition power runs the starter relay, coil and ignition module. the power source for lights and ignition are 2 separate switch contacts. your lights come off the keyswitch relay.

What did the battery light come on on my Harley Davidson?

Rode about 70 miles yesterday. Everything was fine as usual. Stopped for gas. She fired right up. As soon as we hit the road the battery and engine light came on. Pulled into the next gas station and shut her down. Waited a few minutes and she started right back up but lights still on. Headed home.

How to start a Harley Davidson that wont start?

Insert 1 wire into the female terminal that would be #30 in the fuse panel socket. Insert the other WIRE (NOT END of 1st wire) into #87 of the fuse panel socket. 6) Make SURE bike is in NEUTRAL. 7) Turn on ignition ON and Kill switch to run. When you touch both of your installed wires together DOES bike crank./start? Click to expand…

What should the current be on a Harley Davidson starter?

In addition to the starter current draw test, you can measure the voltage at the wire connected to the starter solenoid from the ignition switch. With the ignition in the on/run position and the button pressed, 12 volts should be present at this wire.

Why does my bike not start when I push the starter button?

Pressing the button sends power to the starter solenoid, which sends a large amount of current from the battery to the starter to turn the motor. If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter.

How do you turn off the ignition on a Harley Davidson?

Turn the ignition switch on-off-on-off-on quickly. With a proximity fob system, press the left turn signal switch three times and the right turn signal switch once. The blinkers will flash and the PIN should appear in the odometer window.

How to reset the security code on a Harley Davidson touring?

This article will show you how you can reset the security code, or override the fob on your Harley Davidson Touring. Turn the ignition switch located on the gas tank to “off,” and then turn it to “on.” Figure 1. Turn ignition switch. Press both turn signal switches together and keep them pressed.

Why does my car not start when I put it in neutral?

Today, even putting in neutral after using the shift lock release, the car still has no power and will not start. I do not think it’s a battery issue, but now my car is stuck on the third floor the parking garage in my apartment building and I have no idea how to at least get it to turn on to take to a mechanic.

What does no start, no fuel pump mean?

Not sure if that is the problem though as that fuse may get power after a relay closes? fuse is good. Any other ideas? No start, no spark, no fuel pump. working on my 2008 screaming eagle ultra classic that I just got. Engine is a no start.

Why is my Harley Davidson Ultra Classic not starting?

I have a 2010 ultra classic with ABS. It is not starting. The battery voltage is 12.75 off the battery. When I turn the main switch on, I get a drop to 12.5, and when the kill switch is turned on, I get a drop to 12.38. The self test goes out and hit the start switch with nothing – no volt drop, no starter engage, no nothing. DEAD.

What causes a Harley Davidson to not turn over?

If the bike does not turn over, the issue can be battery, starter, starter relay. If turns over, but no start, determine if the issue is electrical or fuel related. Check for spark.

Why does my 2006 heritage have no spark?

I have a 2006 Heritage. There was no spark to the plugs. Was turning over real good. No spark. Good fuel. The service dept. told me that the coil hardly goes bad. It might be the crankshaft sensor. I replaced it and it started.

What does a red key light on a Harley Davidson mean?

If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car. The procedure for checking the code is posted in the electrical section.

Why is my Harley Davidson Dyna Glide not starting?

If your battery voltage and connections are in good condition, but your engine is still refusing to turn over, the problem may be in the starter circuit. Perhaps the easiest place to begin is at the starter solenoid on the right side of the motorcycle.

What to do if your Harley won’t start?

The Harley service manual suggests to check the electrical connections at the ECM and CKP, as well as check the resistance of the ignition coil before replacing the CKP sensor. That being said, a large number of Dyna owners who have had trouble starting their bikes reported that replacing the CKP sensor immediately cured the problem.

How to test if your starter switch is working?

6) Breaker panel wires to the starter relay were tested. accessories, am I okay in assuming the the ignition switch itself is working? A common wire black/red are used in the circuit panel for ignition, instruments, and lights. The black/red wire is connected to the starter relay via SPL8 (another bundle).

How to fix a Harley Davidson Softail Sportster?

Style and Performance Upgrades Milwaukee Eight Touring Softail & Dyna Sportster Everyday Hog How-To Fix My Hog Projects M8 Cam Upgrade Cam Chain Tensioner Shoe Cam Gear Drive Conversion Carburetor Rebuild Electrical Systems Handlebars 101

What do I need to fix my Harley?

Electrical Systems Handlebars 101 Harley 5 Speed Transmission Project Harley 6 Speed Transmission Rebuild Paint Your Harley Harley Frame Swap Harley Clutch Assembly Upgrade Harley Cafe Racer Build Ride & Rally w/ Fix My Hog Lifestyle – Movies & Series

Are there rear running lights on a Harley?

You don’t say anything about year but unless something has changed, rear turn signals on Harley’s have never been running lights unless you add the kit to make them so. Can’t figure it out. Brake light works, rear turns work, but no rear running lights.

When do the warning lights come on on a Harley Davidson?

Unfortunately, you can drive your brand new Harley off the lot and not get five miles down the road before a warning light comes on. Or, you could be a thousand miles from home when they start flashing. What do they mean?

Are there rear running lights on a V-twin?

No rear running lights! Can’t figure it out. Brake light works, rear turns work, but no rear running lights. Fuses have continuity and wires look good. The brake bulb was blown and I replaced it, so I’m thinking maybe I had a surge.

What to do if no power to ignition or headlights?

And its the only thing left on the checklist that is in line to power the solenoid and headlights. Purchased an aftermarket ignition and spliced it in place of the old ignition switch. A starter relay was inexpensive so I purchased one just in case. I put the old starter relay back into the plug.

When did I replace the battery on my Street Glide?

I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.

What to do when your Harley Davidson won’t start?

Try neutral with clutch pulled in. Also battery connections , solenoid wire. The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power.

Navigation