Why does my GMC Acadia light keep going out?
The driver side HID head lamp would light, then go out, then light again, growing brighter and brighter until it went out. It did this every time the car was started. The dealer diagnosed a bad HID bulb, which is very expensive to replace!
What kind of problems does the GMC Acadia have?
288-horsepower 3.6L V6 6-speed shiftable automatic FWD complete air conditioner failure. Compressor seized and clutch burned. New compressor and clutch required. 288-horsepower 3.6L V6 6-speed shiftable automatic FWD Evaporator problem. Wasn’t fixed permanently The HID passenger side headlamp went out. It was replaced under warranty.
Why does my GMC Acadia make a howling noise?
Replaced rear ac evap core The ac compressor makes an annoying howling noise. They cant figure out the cause. Only makes the noise when the ac compressor is running. 288-horsepower 3.6L V6 6-speed shiftable automatic AWD
How do you adjust the driver’s seat in a GMC Acadia?
If your vehicle has a manual bucket seat you can adjust the seat forward or rearward with the bar located under the front of the seat cushion. Lift the bar to unlock the seat. Slide the seat to where you want it and release the bar. Try to move the seat with your body to be sure the seat is locked in place. 9 Driver Seat Height Adjuster
Where can I find the GMC Acadia owner manual?
A good place to quickly locate information about the vehicle is the Index in the back of the manual. It is an alphabetical list of what is in the manual and the page number where it can be found. Safety Warnings and Symbols
Where is the bar on a GMC Acadia?
If your vehicle has a manual bucket seat you can adjust the seat forward or rearward with the bar located under the front of the seat cushion. Lift the bar to unlock the seat. Slide the seat to where you want it and release the bar.
Is there a problem with the DIC display?
Unfortunately the answer is no. This is going to be an internal cluster failure. There is nothing externally that can cause that if the power and ground are good which is confirmed by the the other gauges operating properly… the internal dic module is going to the the issue and the cluster will require repair or replacement.