Why does my fridge freezer keep cutting out?
An incorrectly adjusted thermostat can cause the freezer’s compressor to start and kick off. The compressor provides the power behind the cooling function of the freezer. Set the thermostat to a lower setting to see if the compressor starts and then stays on. If it does, the compressor doesn’t have a problem.
How do I reset my Liebherr fridge freezer?
Touch the SuperCool icon again until the LED goes out. After the water filter has been changed, the drop symbol on the display must be reset. Activate setup mode by touching the SuperFrost icon for 5 seconds. Touch the freezer compartment Down icon until appears in the display.
Why is my Liebherr freezer not freezing?
The freezer isn’t cold enough An obstructed or failing evaporator fan, a damaged door seal, a faulty thermostat, and an obstructed condenser fan are all culprits. As are a defective thermistor or compressor. All of these components can be checked by a repair technician and the problem quickly diagnosed.
What do you do if your fridge won’t stay cold?
Depending on what’s causing your fridge not to keep perishable foods cold enough, the following procedures might help.
- Make sure your fridge is getting power.
- Check the refrigerator’s thermostat.
- Test the seals on your fridge doors.
- Determine whether the refrigerator is level.
- Clean the condenser coils.
What would cause a freezer to work intermittently?
Faulty Start Relay: The start relay on your freezer provides power to the compressor. This means if the start relay isn’t working, at best your freezer’s compressor will work intermittently – or as is more likely, not at all, meaning your freezer won’t freeze.
Why is my Liebherr freezer beeping?
It always sounds if the freezer temperature is not low enough. The temperature display and the alarm LED flash at the same time. This can be caused by: – warm, fresh food being placed in the freezer, – too much warm air from the outside entering when re-arranging or removing frozen food, – a fault in the appliance.
How do you adjust a Liebherr freezer?
How do you adjust the temperature on a Liebherr refrigerator?
- Press both the Alarm button. and the DOWN. Refrigerator Temperature button. for seven. seconds.
- While the temperature display is blinking, press. both buttons again and the temperature display. will change.
- After making the change, the new temperature.
What temperature should my Liebherr freezer be?
-18°C
The appliance is pre-set for normal operation. We recommend temperatures of +5°C in the refrigerator and -18°C in the freezer. To reduce the temperature: touch the Down icon; on left for refrigerator and on right for freezer. To increase the temperature: touch the Up icon.
Why is my fridge not cold but freezer is working?
When the fridge is not cold but the freezer is, the problem is probably tied to one of your refrigerator’s mechanisms not working as designed. A small fan and motor are mounted near the evaporator, helping draw air over the coils and circulate it to the fridge and freezer.
Why is refrigerator working but freezer not freezing?
Causes: If your freezer won’t freeze, most likely the condenser coils are dirty which reduces the overall cooling capacity of the freezer. Evaporator fan motor is malfunctioning, and since it’s in charge of circulating the air throughout the freezer, this will need to be resolved, pronto.
Why is my Liebherr freezer not working properly?
Ice blockages can also contribute to the freezer not working properly – as can a faulty freezer fan or motor. Faulty connections can cause a failure to start, and a failed capacitor can cause all sorts of problems. This is another common Liebherr troubleshooting issue and can be caused by a number of factors.
What should the temperature be in a Liebherr fridge?
The recommended temperatures of 5 degrees Celsius in the fridge and -18 degrees Celsius in the freezer should be pre-set on your appliance. You can reduce or increase the temperature using the touch icon.
What does it mean when freezer does not work on refrigerator?
Evaporator fan: Every refrigerator contains a set of coils called an evaporator, which makes the inside of the fridge cold. A small fan and motor are mounted near the evaporator, helping draw air over the coils and circulate it to the fridge and freezer. If this fan fails, you’ll likely be stuck with a warm refrigerator.
Where is the drain hole on a Liebherr freezer?
At the bottom of the freezer evaporator there is a drain hole, and as a timed feature the heater melts the ice from the evaporator which drains by means of a flex tubing in a container or small reservoir on top of the freezer compressor At the rear. The freezer compressor is the one on the right side facing the rear.