Why does my Ecu keep blowing?
Another cause of an ECM 1 fuse consistently blowing is a fuel pump problem. When the fuel pump begins to fail it overheats, causing it to drain more amperage (amp); if the amps exceed the amount of amps the ECM 1 fuse allows, the fuse will blow. Replacing the fuel pump should correct this problem.
How can you tell if a fuse has blown on a Honda Accord?
Determine from the chart and, or the diagram on the fuse box lid, which fuse or fuses control that component. Check those fuses first, but check all the fuses before deciding that a blown fuse is not the cause. Replace any blown fuses and check the component’s operation. Turn the ignition switch to LOCK (0).
Where to reset the ECU on a Honda Accord?
If any of these problems are affecting your Civic or Accord, it is very simple to reset the ECU. Keep reading and this how to will guide you through the process. Open the hood and look for the fuse box, which is located near the passenger’s side. The cover contains a diagram of the fuses, which tells you what each fuse is used for and the amperage.
Where are the F62 fuses in a Honda Accord?
F62 Fuses in the vehicle passenger compartment Honda Accord. Locate fuse box. The interior fuse boxes are located on each side of the dashboard. To open an interior fuse box, open the car door. Pull the cover open, then take it out of its hinges by pulling it toward you. driver’s side. coded as follows 1 Indicator relay/hazard warning lamps relay
How do you take cover off Honda ECU?
Remove the cover on the fuse box by pulling the tabs outward and lifting up. Set the cover aside. Figure 1. Locate and remove the cover on the fuse box.
What kind of fuse box does a Honda Accord have?
Honda Accord (1997 – 2002) – fuse box diagram Year of production: 1997, 1998, 1999, 2000, 2001, 2002 Driver’s Under-Dash Fuse box Front View Rear View Number Fuse name A Circuits Protected 1 FUEL PUMP 15 PGM-FI main relay, SRS unit (VA) 2 SRS 10 SRS unit (VB) 3 HEATER CONTROL A/С CLUTCH RELAY COOLING …
If any of these problems are affecting your Civic or Accord, it is very simple to reset the ECU. Keep reading and this how to will guide you through the process. Open the hood and look for the fuse box, which is located near the passenger’s side. The cover contains a diagram of the fuses, which tells you what each fuse is used for and the amperage.
Where is the fuse box on a Honda Civic?
If any of these problems are affecting your Civic or Accord, it is very simple to reset the ECU. Keep reading and this how to will guide you through the process. Open the hood and look for the fuse box, which is located near the passenger’s side.
Remove the cover on the fuse box by pulling the tabs outward and lifting up. Set the cover aside. Figure 1. Locate and remove the cover on the fuse box.