Why do my car gauges turn off and on?
Now the gauges turn off and on, is says damaged keys. Window wont come up, says pass door is open. Headlights flicker, turn signals dont work, inside lights come on and off, and now push start wont work. I can work on the mechanical but don’t know much on the electrical.
Why did my fuel gauge stop working on my explorer?
I hooked up a trailer that was wired incorrectly and it blew the trailer battery power fuse. At the same time, the fuel gauge seemed to st … read more Today, all the sudden, the fuel gauge, power windows and radio, all stopped working on my 2004 ford explorer. everything else seems to work fine.
What should I do if my dash gauges are all out?
Dash gauges are all out and no power windows and no blower for air and heater and its as something shot or blew but the two places that I checked the fuses are not blown. What else might I do to see if the problem can be fixed without going into the shop? have the same problem? Will the vehicle start and run?
Why does my car engine make no noise?
Engine makes no noise at all. It’s sorta like when the battery died 2 months ago, except this time the power windows and doors work, the headlights and interior lights work, though oddly, the radio doesn’t. The radio, FYI, is not the one that came with the car.
Now the gauges turn off and on, is says damaged keys. Window wont come up, says pass door is open. Headlights flicker, turn signals dont work, inside lights come on and off, and now push start wont work. I can work on the mechanical but don’t know much on the electrical.
I hooked up a trailer that was wired incorrectly and it blew the trailer battery power fuse. At the same time, the fuel gauge seemed to st … read more Today, all the sudden, the fuel gauge, power windows and radio, all stopped working on my 2004 ford explorer. everything else seems to work fine.
Dash gauges are all out and no power windows and no blower for air and heater and its as something shot or blew but the two places that I checked the fuses are not blown. What else might I do to see if the problem can be fixed without going into the shop? have the same problem? Will the vehicle start and run?
Why are my gauges not working on my GMC Sierra?
Of course they couldn’t read it with a scanner when it wasn’t working, there was no communication on the Class2 data line. This isn’t something you’re going to fix poking and prodding, and you may even do more damage. The dealer is the best bet to diagnose this, it could by any of the dozen or so modules causing this problem or any of the wiring.
Are there any Windows gauges or interior lights?
Us too any solution. 2008 f150 ford. Also bulb. Now no windows gauges etc… Fuses look good and replaced. 8 people found this helpful. More than likely cluster fuse is bad I had the same problem and the guy said in the post above yours it was F 21 cluster fuse and it says cluster keep a lab in the manual that is it
Why are all of my gauges not registering?
The sending unit wire could be bad or broken, or the circuit from the gauge to the sender is incomplete. Without a ground, the gauge will not register. It is highly unlikely that all the sender units are bad, so we can rule that out. Of course, it is also possible that all the gauges are malfunctioning.
Why are my dash gauges flickering all the time?
The truck starts fine – no issue, starts right up every time. Issues… The gauges: work sometimes, and other times they don’t…and not all at the same time. Banging on the dash doesn’t help, wiggling the battery cables doesn’t help (new battery), tilting the up and down doesn’t help.
Us too any solution. 2008 f150 ford. Also bulb. Now no windows gauges etc… Fuses look good and replaced. 8 people found this helpful. More than likely cluster fuse is bad I had the same problem and the guy said in the post above yours it was F 21 cluster fuse and it says cluster keep a lab in the manual that is it
The truck starts fine – no issue, starts right up every time. Issues… The gauges: work sometimes, and other times they don’t…and not all at the same time. Banging on the dash doesn’t help, wiggling the battery cables doesn’t help (new battery), tilting the up and down doesn’t help.
The sending unit wire could be bad or broken, or the circuit from the gauge to the sender is incomplete. Without a ground, the gauge will not register. It is highly unlikely that all the sender units are bad, so we can rule that out. Of course, it is also possible that all the gauges are malfunctioning.
Why does my car stop working after starting?
The ECU will accordingly regulate the fuel pressure depending on information coming from the sensor. If the sensor malfunctions then the car engine will stop working after starting. If your ignition switch is spoilt you may start the car normally and after driving a few miles the car comes to a complete halt.
Can a faulty ignition switch cause a car to stop?
If your ignition switch is spoilt you may start the car normally and after driving a few miles the car comes to a complete halt. You will notice a loss of power before the car stops. With a faulty ignition switch, you will need to check the switch contacts for wear. Your mechanic can help you with this. Other areas to check are the throttle body.
Why does my car not start when I turn it off?
It is possible that your battery is bad and will not take a charge from your alternator while driving. In that case every time you shut your car off you will not have enough juice to start it again. Inspect your battery – it should have at least 12.5 to 13 volts to start your car, if it doesn’t you will need to replace the battery.
If your ignition switch is spoilt you may start the car normally and after driving a few miles the car comes to a complete halt. You will notice a loss of power before the car stops. With a faulty ignition switch, you will need to check the switch contacts for wear. Your mechanic can help you with this. Other areas to check are the throttle body.
Why does my car not start at idle?
Newer cars control the idle with the throttle body, but if you have an older car with a steel wire to the throttle body – you have an idle control valve. Often this idle control valve can become dirt, and this will cause the idle not to work properly. You can try to clean this valve to see if it gets better.
What causes a car to come to a halt after starting?
Since a vehicle needs fuel to move, any ECU malfunction will cause the vehicle to come to a halt after starting. The ECU controls the engine components via a series of sensors. Over time, the sensors become faulty and pass on erroneous information to the ECU. In this case, you must take your car to a car repair shop.
When do dash lights come on and gauges drop to zero?
Dash lights came on and gauges dropped to zero gasoline w… When driving, occasionally all the dash lights will come on, but the gauges like gas, battery, and mileage, will all drop down to zero. Then my radio shuts off. Fortunately, the car keeps driving. All of this happened today, at a busy intersection, right before a stop light.
How can you tell if your car has an alternator problem?
When your car has an electrical problem you will notice any of the following: The car’s power slowly dies while you’re driving. The car’s lights begin to dim. You have trouble starting the car. The car won’t start at all. If the problem is a bad alternator, your car will slowly lose power.
Can a GM ignition switch be a problem?
Yes, the ignition switch also provided power to many other systems in the car, however it’s possible for only one section of the switch to have a problem and cause other issues. In this case I would highly suspect the ignition switch as they have been problems on many GM vehicles.
What to do if there is no power window?
Check the power window circuit breaker for voltage, key on. That circuit breaker is in fuse box, under right side of dash. Use a testlite to check for voltage. Test the terminals with the key on. If no voltage, you’ll have to check out the ignition switch.
Why are the windows on my car not working?
The reason is that the glass of the windows will stick to their frames. Regulators are not always strong enough to force a window away from its frame if they’re frozen together. Even if it can do that, the regulator will get worn out a lot faster. The switch on the side of your door may not be functioning properly.
Why does my car have no temperature gauge?
Diagnosing Air in the Coolant System Another common reason for a faulty temperature gauge is air making its way into the radiator hoses. Air can pool near the temperature sensor or the thermostat and cause faulty readings (or no readings at all). It can also affect the car’s overall cooling efficiency.
Can a power window be repaired on a late model car?
Fortunately, power windows are usually one of the more reliable systems on a late-model car. And diagnosis and repair are usually pretty straightforward. What’s Up? The most common power window mechanism is pretty basic. There’s a simple regulator mechanism, usually similar to the mechanism used on garden-variety hand-cranked windows.
Why are there no windows and no radio?
However, as a consequence, I’m left with no power to my windows, overhead interior lights, radio, and the dash gauges no longer work. The dash, still displays my air bag yellow symbol, because the wires are disconnected under the drivers seat, it blinks then stays on.
Why is my fuel gauge not working on my GM Truck?
Specifically with the instrument cluster, the speedometer maxed out, RPM didn’t work at all, fuel gauge quit, engine temp gauge quit, transmission temp gauge quit, message center quit, and most of the dummy lights would not work.
Why are all the gauges on my Ford F-250 not working?
My odometer, speedometer, fuel, tach, trip, and all of the gauges quit working. I’ve checked all of the fuses, and cleaned the battery terminal. What else could cause this problem? The cluster may have failed.
What do the gauges do on a Ford?
There are gauges that help you specify the speed at which the car is running along with many indicator lights such as the check engine light or the low fuel light.