Why do I have a high idle problem on my Nissan?
That’s crossed my mind as a potential cause, I took it to a Nissan dealer and they didn’t have a solid answer, but said it was the computer and wanted to put a new ecu in. Then another Nissan dealer out near the dealer I bought it from said it was not the computer.
Why is my Nissan alternator not working properly?
Shops report that Nissan Alternator Problems can sometimes be traced to an intermittent in the plug that goes into the voltage regulator in the alternator. The factory harness is short (less than 1 foot) and can fray the wires in the terminals.
When to fix a Nissan engine code P0300?
When P0300 occurs it should be fixed immediately as long term driving with engine misfires could cause consequential damage to the engine in your Nissan. Many times P0300 occurs when there are worn out spark plugs, spark plug wires, or a faulty ignition coil. Nissan code P0300 should be repaired immediately.
What are the symptoms of a bad starter relay?
Listed below are a few of the symptoms of a damaged or worn out starter relay. If you notice these warning signs, make sure you contact a local ASE certified mechanic to completely inspect your vehicle as these symptoms might indicate problems with other components. 1. Vehicle does not start
Listed below are a few of the symptoms of a damaged or worn out starter relay. If you notice these warning signs, make sure you contact a local ASE certified mechanic to completely inspect your vehicle as these symptoms might indicate problems with other components. 1. Vehicle does not start
Why does my Car start intermittently after starting?
In this case, it’s important that you contact a mechanic as soon as possible so they can determine what is causing the intermittent contact. In many cases an intermittent starting problem is linked to a bad wire connection that may become dirty due to exposure under the hood.
Why does my hid kit only turn on one side?
Only one side is working on my HID kit or LED kit. If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits).