Why are the indicators on my Mercedes not working?
My indicators stopped working today, hazard lights were OK. Checked fuse 5 (OK), changed it with new, rotated in fuseholder, still not working. Switched on hazard, switched on indicator, hazard off and indicators keept going. Indicators have been working since. Have anyone else had the same experience, explanation ? The wiring diagram is attached.
What to do if your directional indicator is not working?
But to test, or to get the indicators to work in an emergency pinch disconnect the flasher switch and jumper pins 15 and 49 on the connector, pin 49 supplies 12volts to the directional indicator relay. Or open the flasher relay and dispose of the moveable “guts” and jumper pin contacts 15 and 49. That’s what I did until my flasher switch arrived.
How can I tell if my turn indicator is working?
For use in fault finding your turn indicator system refer to the circuit/wiring diagram section here. It’s also worth a mention to check the operation of the hazard light switch on the steering column, if this is not functioning correctly the indicators will not work properly as it forms an integral part of the indicator electrical circuit.
Where is the intermittent turn indicator on a sprinter?
Locate the fuse board by removing the plastic panel beneath the steering column, (turn-screw latch at top of cover) at the base of the fuse board you will see a thick red wire connected to a lug terminal this is +12 live constantly, be sure not to short this to the chassis! – look below this and you will see two small relays placed to one side.
My indicators stopped working today, hazard lights were OK. Checked fuse 5 (OK), changed it with new, rotated in fuseholder, still not working. Switched on hazard, switched on indicator, hazard off and indicators keept going. Indicators have been working since. Have anyone else had the same experience, explanation ? The wiring diagram is attached.
But to test, or to get the indicators to work in an emergency pinch disconnect the flasher switch and jumper pins 15 and 49 on the connector, pin 49 supplies 12volts to the directional indicator relay. Or open the flasher relay and dispose of the moveable “guts” and jumper pin contacts 15 and 49. That’s what I did until my flasher switch arrived.
Where is the turn signal on a Mercedes?
The turn signal switch is part of the combination switch found in the steering column and is mounted right behind the steering wheel. You may also notice that the wiper switch is not working either.
Why is the hazard light not working on my Mercedes?
Turned out to be a bad Hazard Light switch. Happens all the time. One way of dealing with the issue instead of opening the relay, is to cycle the hazard button a bunch of times which seems to scuff the oxidation enough that things once more make proper contact.
How is automobile brake failure indicator-engineering projects?
The project ‘Automobile Brake Failure Indicator’ is the solution to this global issue. You might be wondering how this project is responsible to lower accident rate. Well, this indicator circuit keeps an eye on the condition of the brake at regular intervals and provides audio-visual indication of the situation.
What does the ABS warning light on a Mercedes mean?
If the ABS warning light is also illuminated this signals that the braking system has malfunctioned and your brakes may not work properly. In this case the Electronic Brake Force Distribution (EBD) warning light may also be illuminated. Can I still drive with my parking brake and brake fluid light on?
How does the brake failure indicator ( IC3 ) work?
IC3 gets triggered by the low output of IC2 which passes through C2. Finally, the buzzer beeps and green LED turns on to indicate that the brake is working smoothly. However, in case of failure, even after the brake is applied, red LED keeps on glowing and buzzer doesn’t sound. It is easy to design the circuit of Automobile Brake Failure Indicator.
What causes a Mercedes Benz brake to fail?
There are three common types of failures that happen with the Drive-by-Wire brakes on the Mercedes Benz. Operating time of Component of A7/3 is exceeded. Complete failure of the SBC/Electro-Hydraulic Brake System Hydraulic Pump In a few cases a defective brake switch could cause the same error message.
If the ABS warning light is also illuminated this signals that the braking system has malfunctioned and your brakes may not work properly. In this case the Electronic Brake Force Distribution (EBD) warning light may also be illuminated. Can I still drive with my parking brake and brake fluid light on?
What is the SBC brake failure error code?
Some of the errors reported are: 1 SBC Control module failure 2 STOP VEHICLE displayed on instrument cluster 3 Brake defective stop vehicle 4 REDUCED BRAKING POWER – VISIT WORKSHOP (Replace brake light switch first.)
What does it mean when brake warning light comes on?
If it comes on with the brake warning light, it could indicate that the brake system is failing and you should stop straight away and call for recovery if you have breakdown cover. For roadside assistance, you can call the RAC on 0330 159 1111 even if you’re not a member.
What’s the name of the Mercedes Benz parking light?
Parking light. P21/5W. Front turn signal. P21/5W. Rear turn signal. P21W. Tail light. 5007 or 12821 or R5W. Tail light.
What to do when your Mercedes goes into limp mode?
You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level.
Do you need dipstick to check Mercedes transmission?
The car doesn’t come with a dipstick to check the transmission level but you can order one online for under $20. You will need Dipstick Tool for 722.6 722.9 Mercedes-Benz Transmission for measuring fluid level. Watch the video below to learn how to check the transmission fluid level on your Mercedes-Benz.
What kind of car is the Mercedes ML?
Used 2008 Mercedes-Benz M-Class ML 320 CDI Sport Utility 4D Edit OptionsMileage: 139,437 4.4 Consumer Write a review View Gallery For Sale Near You 33 Mercedes-Benz M-Class vehicles in your area. Used 2007 Mercedes-Benz ML 350 4MATIC $8,599 Reduced California Motors Direct Montclair Used 2010 Mercedes-Benz ML 350 2WD $9,500 VW-BENZ Used 2006
What’s the price of a 2008 Mercedes ML?
See pricing for the Used 2008 Mercedes-Benz M-Class ML 320 CDI Sport Utility 4D. Get KBB Fair Purchase Price, MSRP, and dealer invoice price for the 2008 Mercedes-Benz M-Class ML 320 CDI Sport Utility 4D.
How much does a Mercedes Benz ML 350 cost?
Used 2007 Mercedes-Benz ML 350 4MATIC $8,599 Reduced California Motors Direct Montclair Used 2010 Mercedes-Benz ML 350 2WD $9,500 VW-BENZ Used 2006 Mercedes-Benz ML 350 4MATIC $7,400 Reduced BLOK Charity Auto Clearance Used 2006 Mercedes-Benz ML 350 4MATIC $8,500 Private Seller Used 2008 Mercedes-Benz ML 350 4MATIC $9,995 Reduced