Why are the doors not working on my Mercedes S500?
ITS A REOCCURRING PROBLEM, A TEMPORARY FIX FOR MOST OF THE SYSTEM IS REPLACING THE FUSE IF THE PROBLEM CONTINUES FOR ONE ITEM AND NOT THE OTHERS (I.E. THE TRUNK STILL DOESN’T WORK BUT THE DOORS DO.) THEN ITS USUALLY PRESSURIZATION ISSUE AND EVEN THAT CAN BE A SIMPLE FIX IF YOU CAN FIND THE AIR LEAK.
Why does my 2005 Mercedes Benz S600 not lock?
2005 S600, doors won’t lock and unlock, soft close doors don’t work, rear headrests won’t go down, trunk won’t open. Problem with pneumatic system, auto assist doors don’t work, trunk doesn’t close properly unless you pull switch in hole inside to the left, driver door unlocks much slower than rest. Doors won’t lock or open. Truck does not open.
What is the number of the door control module?
If so it is just plug and play so to speak. no i meant the 210 820 77 26 is the part number…my window doesnt roll up or down…or the power seats dont move….checked everything no blown fuses… Ive heard of some luck with disconnecting/reconnecting the module to reset.
Where are the fuses on the door control module?
Fuses f27 & f29 (30A) protect the entire modules so if some motors work it cannot be the fuse. It could be chafed wiring at the connectors on the floor under the seat, or a bad earth connection possibly down there. Do some local inspection. :thumbsup: N32/1 and N32/2 are located under the relevant front seats.
Are there any problems with the Mercedes CL500?
Keep track that the ABC fluid is good is another important issue with any ABC equipped Benz. These cars are heavy. Your going to burn through front pads and tires every 20,000. But my CL is a pleasure and has been very dependable car overall. My 2000 CL500 just hit 88]
2005 S600, doors won’t lock and unlock, soft close doors don’t work, rear headrests won’t go down, trunk won’t open. Problem with pneumatic system, auto assist doors don’t work, trunk doesn’t close properly unless you pull switch in hole inside to the left, driver door unlocks much slower than rest. Doors won’t lock or open. Truck does not open.
How does the fuel pump work on a CL500?
The pump sends air into the manifold to dilute the rich air/fuel mixture when the motor is cold.
ITS A REOCCURRING PROBLEM, A TEMPORARY FIX FOR MOST OF THE SYSTEM IS REPLACING THE FUSE IF THE PROBLEM CONTINUES FOR ONE ITEM AND NOT THE OTHERS (I.E. THE TRUNK STILL DOESN’T WORK BUT THE DOORS DO.) THEN ITS USUALLY PRESSURIZATION ISSUE AND EVEN THAT CAN BE A SIMPLE FIX IF YOU CAN FIND THE AIR LEAK.
Why is my smart key not working on my Mercedes S500?
Smart key won’t open door, battery is fine. Can’t unlock doors or trunk from switches inside. Blade key was working fine for several months, now would not totally release drivers door had to get roadside assistance to manually unlock.
How much does a Mercedes Benz S500 cost?
The average cost for a Mercedes-Benz S500 General Diagnosis is between $143 -$180. Learn More The central locking system does not work from the smartkey nor from the interior buttons.
How does auto close work on a Mercedes Benz?
Older Mercedes-Benz models before 1995 will most likely not have the auto close feature. They may have a micro switch on the window regulator that the window toggles on and off when it reaches the top or bottom position. When I park or turn off the car and try to close the windows, they do not go up all the way.
How do I re sync my Mercedes sunroof?
Otherwise, re-syncing will not work. Put the key to position 1 or 2. Do not start the car. Pull the window button to the first position (the first click on the button) until the window completely closes. Hold for 2-5 seconds until you hear a click. Check if the one-touch feature and the other problems are fixed.
Smart key won’t open door, battery is fine. Can’t unlock doors or trunk from switches inside. Blade key was working fine for several months, now would not totally release drivers door had to get roadside assistance to manually unlock.
Older Mercedes-Benz models before 1995 will most likely not have the auto close feature. They may have a micro switch on the window regulator that the window toggles on and off when it reaches the top or bottom position. When I park or turn off the car and try to close the windows, they do not go up all the way.
Otherwise, re-syncing will not work. Put the key to position 1 or 2. Do not start the car. Pull the window button to the first position (the first click on the button) until the window completely closes. Hold for 2-5 seconds until you hear a click. Check if the one-touch feature and the other problems are fixed.
What’s the price of a Mercedes Benz door lock?
Problems with the pneumatic system can cause closing assist and door lock issues. The average cost for a Mercedes-Benz S500 General Diagnosis is between $143 -$180. Learn More The central locking system does not work from the smartkey nor from the interior buttons.
The average cost for a Mercedes-Benz S500 General Diagnosis is between $143 -$180. Learn More The central locking system does not work from the smartkey nor from the interior buttons.
How to fix soft close on Mercedes Benz?
Repair of the Trunk’s Soft Close feature. Disconnect and reconnect the battery after reinstalling the repaired unit or the new replacement unit in order for Repair of the Trunk’s Soft Close feature. Disconnect and reconnect the battery after reinstalling the repaired unit or the new replacement unit in order for Skip navigation Sign in
Why is my Mercedes CL500 window not closing?
My 2000 CL500 will do this if the Voltage is low in the battery. These cars suck the life out of a Battery. You need to replace it every 2-3 years in this beast.
Why does my S class door close assist stop working?
All that is caused by faulty close assist pump. In most cases drivers door fails to close itself first as it’s used the most. Many people reset pump by pulling the fuse #9 out trunk fuse panel. After some time pump stops operating again because the problem is not repaired with reset.
Why is my drivers window not closing completely?
Thx for any suggentions/help. My 2000 CL500 will do this if the Voltage is low in the battery. These cars suck the life out of a Battery. You need to replace it every 2-3 years in this beast. Does it go up and seal if you hit the button to force it up ?
Why is the window not closing when I close the door?
Noticed that the window opens slightly when I open the door (as it should) but does not go up and seal when I close the door. The soft close of the door is functioning correctly. I know there is a sensor under the door lock that I should try to reset first.
Why are the power windows on my car not working?
When I had a similar problem with my ’97, it was the driver’s side switch. Here’s the weird part. All the rest of the window switches work through this switch, so if it’s toast, none of the others will work. Out of curiosity, can you control the power windows from the other switches?
What causes a power window to stop working?
The problem occurs after countless hundreds of times of opening and closing the door. At some point the wiring bundle that goes from the door into the door post will become brittle and the wires will actually break.
Why does my Volvo S70 have no AC?
Symptoms on my 1997 S70 was either there was a quick fan blow, everything stopped then the two lights flashed for 20 secs or nothing happened the two lights just flashed, no A/C and no fan. I took it to the dealer for a very expensive repair close to 700 dollars and the fix was a fan motor drawing excessive current.
How can I tell if there is a leak in my a / C system?
You can and should pull a vacuum, look at the reading on the manifold gauge set, let it sit for some amount of time (overnight is best), and see if the vacuum reading drops, because if it does, there’s a leak somewhere. But the vacuum itself is really almost no help in finding the leak.
Can a vacuum leak affect a positive crankcase ventilation system?
This type of leak can also affect the Positive Crankcase Ventilation (PCV) system. Here is a list of performance problems to keep in mind, as they might possibly be related to a vacuum leak:
What happens if you have a vacuum sensor leak?
A MAP sensor vacuum leak can upset ignition timing and engine stability and efficiency. A vacuum leak can also prevent an EGR valve from opening, cause engine overheating, and increase harmful emissions. This type of leak can also affect the Positive Crankcase Ventilation (PCV) system.
How long does it take for 4WD vacuum pump to shut off?
You will completely bypass the electronics of the 4wd system and apply direct vacuum to your hubs. If you have no leaks in the vacuum lines that go out to your hubs from the solenoid, then the vacuum pump should shut off in under 45 seconds (once it fully pressurizes).
What are the symptoms of a vacuum leak?
Common Symptoms of an Engine Vacuum Leak 1 Engine Running Problems. An engine with a vacuum leak could potentially run normally, but it may idle faster than usual, idle roughly, misfire, hesitate, or stall. 2 Fuel Economy and Emissions. 3 Check Engine Light. 4 Engine Damage. 5 Other Issues.
All that is caused by faulty close assist pump. In most cases drivers door fails to close itself first as it’s used the most. Many people reset pump by pulling the fuse #9 out trunk fuse panel. After some time pump stops operating again because the problem is not repaired with reset.
Why does my rear door lock not work?
The rear doors will not unlock but if you unlock them manually when you drive the car they will lock. Fuel door lock will only work to lock and will.not unlock. Can any one help with my problem?
Why is my door handle slipping off my Mercedes?
Usually over a period of time, there is a tendency that the lock has developed play within it and Mercedes door handle has slipped off the opening tongue. The instructions to remove the exterior Mercedes door handle are present in this link .
Why is my Mercedes Benz door lock not working?
THEN ITS USUALLY PRESSURIZATION ISSUE AND EVEN THAT CAN BE A SIMPLE FIX IF YOU CAN FIND THE AIR LEAK. Auto assist door closing and locking stopped working. Truck has to be manually opened. Patched a leak in the line but still won’t work.
THEN ITS USUALLY PRESSURIZATION ISSUE AND EVEN THAT CAN BE A SIMPLE FIX IF YOU CAN FIND THE AIR LEAK. Auto assist door closing and locking stopped working. Truck has to be manually opened. Patched a leak in the line but still won’t work.