Why are my windows not closing on my Saab 9-3 convertible?

Why are my windows not closing on my Saab 9-3 convertible?

Window calibration in Saab 9-3 convertible Situation :the front windows are not closing completely. After they come up, they go 30% again down while the soft-top roof is up. This is the pinch protection and it normally happens, when someone has the fingers in the wrong place (between the glass and the roof).

When to replace a broken power window motor?

If one of the power windows in your vehicle fails to function, it may be the result of a broken power window motor. If you have identified the motor as the culprit, replacing it is fairly straight forward, though it can be time consuming.

Where is fuse 5 on Saab 9-3 convertible?

It’s the fuse #5 (description in manual : Control module in front doors; Park Brake Shift Lock (automatic transmission)) in the left row, you see the position in the second photo. Pull it out with the orange tool, which you see in the lower right corner of the photo. You will find it on the inner side of the fuse box case.

What kind of key fob does a Saab use?

2008-2010 9-3 Convertible 1 on vehicle. 2008-2010 9-3 Sport Combi 1 on vehicle. NOT FOR 2003 CV MODELS!!KEY FOB MUST BE PROGRAMMED TO VEHICLE IN ORDER TO FUNCTION!! Will require GM on line security software and Tech 2 programmer. Original P/number is 12783781.Saab 9-3 Alarm Remote Fob/Transmitter.

When did the Saab 9 3 convertible come out?

2003-2007 9-3 Sport Sedan 2 on vehicle. 2004-2007 9-3 Convertible 2 on vehicle. 2006-2007 9-3 Sport Combi 2 on vehicle. 2008-2010 9-3 Sport Sedan 1 on vehicle. 2008-2010 9-3 Convertible 1 on vehicle. 2008-2010 9-3 Sport Combi 1 on vehicle.

Are there any Saab parts in the USA?

Saab USA Parts – Official provider of Saab Parts & Accessories. Genuine Saab Right Rear Outer Tail Lamp Circuit Board. For Passengers Side, Outer Tail Lamp. $35.96 $1,236.53 $593.82 120 AMP replacement unit!! For cars WITHOUT heated seats. Currently in stock. $422.63 Genuine Saab Right Headlight. Xenon. (9-5)2010-2011) [12842568] $1,023.53

What are the parts for the windshield wiper on a Saab?

The windshield wiper motor is responsible for powering the wiper blades when they are turned on. Windshield wiper linkage / transmission (Saab Part Number 12757154) is commonly replaced with this part and is sold separately HERE. $193.69 NOTE: NOT FOR 2003 Saab 9-3 CV!

Where are the switches located on a Saab power window?

No, this is not possible. The 2002 9-3 and 9-5 were fitted with a switch pack assembly housed in the center console which was a single unit. From 2004 onward the switch setup was totally changed with the DDM (Driver Door Module) type switches. These consist of both a microprocessor and switch which is located in the driver’s door.

How to reset the window on a Saab?

If you have reset the window as per the SAAB manual i.e…. 1 Close the doors. 2 The car must be running at idling speed. calibration. be kept depressed the whole time. closed. has fully opened. confirmed with a “chime”. require calibration.

Can you change the switch pack on a Saab 9-3?

No, this is not possible. The 2002 9-3 and 9-5 were fitted with a switch pack assembly housed in the center console which was a single unit. From 2004 onward the switch setup was totally changed with the DDM (Driver Door Module) type switches.

Window calibration in Saab 9-3 convertible Situation :the front windows are not closing completely. After they come up, they go 30% again down while the soft-top roof is up. This is the pinch protection and it normally happens, when someone has the fingers in the wrong place (between the glass and the roof).

What does the power window on a Saab do?

Apart from controlling the power windows it also reads their status. Additionally, it controls and heats the driver’s door mirror motor and central locking system motor. It also illuminates all door buttons and the courtesy light installed at the bottom edge of the door.

Where are the switches located on a Saab 9-3?

The 2002 9-3 and 9-5 were fitted with a switch pack assembly housed in the center console which was a single unit. From 2004 onward the switch setup was totally changed with the DDM (Driver Door Module) type switches. These consist of both a microprocessor and switch which is located in the driver’s door. The two are clearly not interchangeable.

What are the non essential accessories on a Saab?

The circuit for non-essential accessories powers up only after the engine has started as they are not necessary when starting. By isolating them, optimum power is made available to the starter motor and other starting essentials during the starting process. Non-essentials include power windows, heated seats, wipers and turn signals.

When did the second generation Saab 9-3 come out?

In this article, we consider the second-generation Saab 9-3, produced from 2002 to 2014. Here you will find fuse box diagrams of Saab 9-3 2003, 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

Where is the fuse box on a Saab 9-3?

It is located behind the cover on the driver’s side of the instrument panel. Two fuse boxes are located near the battery. The fuse box is located behind the cover on the left side of the trunk. Amp. Amp.

What are the lights on a Saab 9-3?

Right-hand stop light; rear left turn signal; left tail light; rear fog light; left reversing light; license plate lighting; trunk lighting; trailer lights Front right parking light; front right turn signal; left and right side turn signal; right high beam; left low beam; front left fog light

How do I close the window on my Saab 9-3 / 9-5?

Raise the window fully. Hold the button up during the entire operation. Wait for at least 1 second when the window is in the top position. 6. Lower the window fully. Hold the button depressed during the entire operation. 7. Raise the window fully. Hold the button up during the entire operation.

What are the most common problems with the Saab 9-3?

We carry the motor in Valeo, which is the OEM supplier of these motors to Saab. Broken suspension springs are a common problem in new-gen 9-3’s, and are something to keep an eye out for. For whatever reason, the springs snap near the perch, causing a knocking/popping noise.

In this article, we consider the second-generation Saab 9-3, produced from 2002 to 2014. Here you will find fuse box diagrams of Saab 9-3 2003, 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

Why are my electric windows on my Saab not working?

Electric windows can be extremely convenient, but when they don’t work, it can become a very frustrating and expensive problem. If your driver window (it also applies to all other windows) decided to go back down to about 2/3, guess it’s the Pinch protection feature .

What do I do if my front window wont close?

Reset the pinch protection by removing and fitting fuse F5 from the instrument panel electrical centre (IPEC). The pinch protection for both door modules is now reset and both front windows can be programmed. 3. Start the car. 4. Lower the window fully.

How can I Fix my Saab front window not closing?

Reset the pinch protection by removing and fitting fuse F5 from the instrument panel electrical centre (IPEC). The pinch protection for both door modules is now reset and both front windows can be programmed. 3. Start the car. 4. Lower the window fully. Hold the button depressed during the entire operation. 5. Raise the window fully.

How does window calibration work on a Saab 9-3 convertible?

HOME | RIDES | PRACTICAL | SAABS | DRAMA | MUSIC | APPS | OTHER | WORLD MAP Sunday, April 24, 2011 Window calibration in Saab 9-3 convertible Situation :the front windows are not closing completely. After they come up, they go 30% again down while the soft-top roof is up.

What’s the best way to reset an auto window?

Close the windows so you can reset the automatic function. Step 3: Roll the window completely down. Roll the window completely down and hold the auto button down for 10 seconds. Step 4: Roll the window completely up.

It’s the fuse #5 (description in manual : Control module in front doors; Park Brake Shift Lock (automatic transmission)) in the left row, you see the position in the second photo. Pull it out with the orange tool, which you see in the lower right corner of the photo. You will find it on the inner side of the fuse box case.