Who was the manager of Allis Chalmers tractor division?
In 1940 the Allis-Chalmers Tractor Division Manager Harry Merritt acquired the rights to Luebben’s baler for the company to use. Engineers at Allis-Chalmers immediately began modifying and building a baler based off of Luebben’s model.
Where is the serial number on an Allis Chalmers tractor?
Allis Chalmers WD photos… Full dimensions and tires The WD serial number is stamped into the rear of the transmission case on the left side. how to read serial numbers…
How does the Allis Chalmers dual clutch system work?
The Allis-Chalmers WD featured Two-Clutch Power Control and power-shifted rear wheels. The dual clutch system used a foot-operated dry clutch to disconnect the PTO and driveline from the engine. A hand-operated wet clutch allowed the PTO to operate while the tractor was slowed or stopped.
When did Allis-Chalmers get their first patent?
The earliest patent granted to Allis-Chalmers for their baler was in December 1945. From the illustrations in the patent application, this patent appears to be on the chassis and delivery system to the bale chamber. A patent granted to Allis-Chalmers in 1946 illustrates and describes the bale forming chamber and tying mechanism.
When did Briggs and Stratton buy out Allis Chalmers?
In 1983, Allis sold Simplicity and Allis was purchased by Deutz, ending the Allis-Chalmers brand name for 25 years. In 2008, Briggs & Stratton (the new owner of Simplicity) resurrected the Allis-Chalmers brand name on the new AC130 line of lawn tractors.
In 1940 the Allis-Chalmers Tractor Division Manager Harry Merritt acquired the rights to Luebben’s baler for the company to use. Engineers at Allis-Chalmers immediately began modifying and building a baler based off of Luebben’s model.
When was simplicity tractors bought by Allis Chalmers?
Simplicity produced lawn tractors for Allis-Chalmers, and the company was purchased by Allis in 1965. In 1983, Simplicity was sold by Allis to management.
How big is an Allis Chalmers Roto Baler?
According to C.H. Wendel’s book The Allis-Chalmers Story, Allis-Chalmers applied for a trademark status in 1948, and the trademark was issued in 1950. The Roto-Baler could produce bale sizes from 14″ to 22″ in diameter, and, depending on the size, could weigh from 40 to 100 pounds.