Where to get a serpentine belt for an AC compressor?
Go to an auto parts store and get them to lookup the belt you need. Then, used the old belt to measure the circuit without driving the compressor. Serpentine belt part numbers are based on length and number of ribs. Once you know the length you need w/o the compressor, they should be able to get you one that will work.
Where does the bypass belt go on an AC compressor?
You can definitely use the A/C bypass belt permanently. Note that in the diagram, you will have the bottom setup (i.e. with A/C). The bypass belt will go straight from the crank pulley (#1) to the power steering pump (#3). It will just clear the top of the A/C compressor pulley (#2).
Where does the bypass belt go on a Mercedes Benz?
The bypass belt will go straight from the crank pulley (#1) to the power steering pump (#3). It will just clear the top of the A/C compressor pulley (#2). As for replacing the compressor, If it’s actually the compressor pump that is the problem, you will have to recharge the system because removing the compressor does open it.
Can you replace the a / C bypass belt without tools?
Replacing the belt is easy. I can actually do it without any tools, although the “prescribed method” is to use a wrench to release pressure on the tension pulley (#7 on the diagram linked below). You can definitely use the A/C bypass belt permanently. Note that in the diagram, you will have the bottom setup (i.e. with A/C).
How to bypass an air conditioning compressor with a serpentine belt?
Take the marked string to the parts store and advise them that you need a belt of that length. Serpentine belts have varied sizes; the last four digits of the part number are the length of the belt in centimeters. Get the next available size up and down to make certain you find a good fit.
Is there a way to bypass the compressor?
There is a way around this problem however; you can actually bypass the compressor all together with a different serpentine belt. Locate the serpentine belt at the front of the engine. It is a rubber belt that goes over all of the accessories of the engine.
How do you put a belt on a truck?
Pull the serpentine belt from the pulleys on the front of the truck. Weave the string over all of the pulleys, just as the old belts was, but skip the compressor. When the two ends of the string meet, make a mark on the string with a marker. Take the marked string to the parts store and advise them that you need a belt of that length.