Where should the straps be on a rear-facing car seat?
On rear-facing car seats, the shoulder straps should come through the car seat slots at or just BELOW your child’s shoulders. On forward-facing seats, the shoulder straps should be at or just ABOVE the shoulders.
Does the seatbelt go over the car seat?
The vehicle seat belt can always be used in the traditional way, where it is routed through the belt path of the car seat and buckled in. The seat belt holding a car seat must be locked at all times, which means the belt can not get looser.
How long should you be rear-facing?
Babies are safest in a rear-facing restraint, and would only be expected to outgrow these restraints when they are two to three years old. Children should stay rear-facing for as long as possible. As your child grows, it may appear that there is no room for their legs when they are restrained in this position.
Can my 1 year old sit in a front facing car seat?
However, if you were to ask if your 1-year-old should sit in a front-facing car seat, the definitive answer to that is a resounding “No,” according to the American Academy of Pediatrics, who recommend keeping your child rear-facing until the age of two, or to the highest weight and height allowed by the carseat …
When can you use seatbelt with car seat?
All children whose weight or height exceeds the forward-facing limit for their car safety seat should use a belt-positioning booster seat until the vehicle seat belt fits properly, typically when they have reached 4 feet 9 inches in height and are 8 to 12 years of age.
What is the height and weight for forward facing?
Maximum forward-facing harness weight range can vary from 40-85+ pounds. Make sure child is within weight/height limits for the seat and head is more than one inch below the top of the car seat shell. READ the instruction manual AND the safety belt/seat section in your vehicle manual for proper installation guidance.
How do you install a car seat with a seat belt?
Step 1: Using your car seat’s manual, find its seat belt path; this is a set of slots or holes generally located near the Latch connector strap path on the seat. Step 2: Feed the seat belt strap through the appropriate car-seat belt path and buckle the seat belt. Step 3: Pull the vehicle’s seat belt all the way out of the retractor. Do this slowly.
Can a rear facing infant car seat be installed without a belt?
They’re always there, though. A rear facing only infant car seat has one belt path on the base and another belt path on the seat itself for installing it without the base (check your car seat manual — some require a base after a certain weight).
How to install a 3 point seat belt?
Replacement Seat Belt 3 point formerly, #welr, FMVSS Federal Safety Approved Retractable Belt: CAUTION: Read these seatbelt instructions for 3 point retractable replacement seat belts thoroughly before installing this replacement safety harness.
Where is the belt path on a car seat?
Any car seat that is installed (versus a booster that is just sitting on a the car’s seat) has at least one belt path. That’s the spot on the car seat where the seat belt or lower anchor strap goes through. Sometimes they’re clearly labeled and obvious; other times they’re more subtle. They’re always there, though.