Where is the washer fluid pump on a Honda Civic?
Engage the parking brake, and open the bonnet. Raise the front of the vehicle with the automotive jack, and support it with jack stands. Chock the rear wheels. Crawl underneath the front of the vehicle, and locate the washer fluid pump. It is on the lower-left side of the washer fluid reservoir.
What to do if your washer reservoir is leaking?
Check the bottom of the reservoir where the pump is with a flashlight to see if any washer fluid is leaking out. Operate the washer lever or switch and verify that the washer fluid is transferring from the washer reservoir to the washer nozzles.
How do you remove a washer reservoir from a car?
Removing the washer reservoir from the upper engine compartment along the fender Step 1: Remove the bolts. Locate the washer reservoir. Remove the bolts that secure the washer reservoir to the fender or body of the vehicle. Step 2: Remove the harness plug. Remove the harness plug connected to the washer pump.
How do you remove a washer pump from a car?
Step 1: Remove the reservoir bolts. Locate the washer reservoir under the hood. Remove the bolts that secure the washer reservoir to the fender or body of the vehicle. Step 2: Remove the connection to the washer pump. If there is a harness plug on the washer pump, then remove the plug.
Check the bottom of the reservoir where the pump is with a flashlight to see if any washer fluid is leaking out. Operate the washer lever or switch and verify that the washer fluid is transferring from the washer reservoir to the washer nozzles.
Removing the washer reservoir from the upper engine compartment along the fender Step 1: Remove the bolts. Locate the washer reservoir. Remove the bolts that secure the washer reservoir to the fender or body of the vehicle. Step 2: Remove the harness plug. Remove the harness plug connected to the washer pump.
Step 1: Remove the reservoir bolts. Locate the washer reservoir under the hood. Remove the bolts that secure the washer reservoir to the fender or body of the vehicle. Step 2: Remove the connection to the washer pump. If there is a harness plug on the washer pump, then remove the plug.
How do you install a washer in a car?
Install the washer reservoir onto the fender or body in the engine compartment. Step 6: Plug in the harness to the washer pump. If you had to cut the wires, you will need to strip the wires with a wire stripper to the harness and to the pump. Insert two butt connectors with heat shrink tubing and crimp the wires to the butt connectors.